[PATCH net-next 0/3] net: ag71xx: phylink validate implementation updates

STALE1726d

5 messages, 3 authors, 2021-11-18 · open the first message on its own page

[PATCH net-next 0/3] net: ag71xx: phylink validate implementation updates

From: "Russell King (Oracle)" <linux@armlinux.org.uk>
Date: 2021-11-17 16:46:08

Hi,

This series converts ag71xx to fill in the supported_interfaces member
of phylink_config, cleans up the validate() implementation, and then
converts to phylink_generic_validate().

The question over the port linkmode restriction has been answered by
Oleksij - there is no reason for this restriction, so we can go the
whole hog with this conversion. Thanks!

 drivers/net/ethernet/atheros/ag71xx.c | 96 +++++++++++------------------------
 1 file changed, 29 insertions(+), 67 deletions(-)

-- 
RMK's Patch system: https://www.armlinux.org.uk/developer/patches/
FTTP is here! 40Mbps down 10Mbps up. Decent connectivity at last!

[PATCH net-next 1/3] net: ag71xx: populate supported_interfaces member

From: Russell King <hidden>
Date: 2021-11-17 16:46:24

Populate the phy_interface_t bitmap for the Atheros ag71xx driver with
interfaces modes supported by the MAC.

Signed-off-by: Russell King <redacted>
---
 drivers/net/ethernet/atheros/ag71xx.c | 26 ++++++++++++++++++++++++++
 1 file changed, 26 insertions(+)

diff --git a/drivers/net/ethernet/atheros/ag71xx.c b/drivers/net/ethernet/atheros/ag71xx.c
index 88d2ab748399..8d55ce266aa3 100644
--- a/drivers/net/ethernet/atheros/ag71xx.c
+++ b/drivers/net/ethernet/atheros/ag71xx.c

@@ -1178,6 +1178,32 @@ static int ag71xx_phylink_setup(struct ag71xx *ag)
 	ag->phylink_config.dev = &ag->ndev->dev;
 	ag->phylink_config.type = PHYLINK_NETDEV;
 
+	if ((ag71xx_is(ag, AR9330) && ag->mac_idx == 0) ||
+	    ag71xx_is(ag, AR9340) ||
+	    ag71xx_is(ag, QCA9530) ||
+	    (ag71xx_is(ag, QCA9550) && ag->mac_idx == 1))
+		__set_bit(PHY_INTERFACE_MODE_MII,
+			  ag->phylink_config.supported_interfaces);
+
+	if ((ag71xx_is(ag, AR9330) && ag->mac_idx == 1) ||
+	    (ag71xx_is(ag, AR9340) && ag->mac_idx == 1) ||
+	    (ag71xx_is(ag, QCA9530) && ag->mac_idx == 1))
+		__set_bit(PHY_INTERFACE_MODE_GMII,
+			  ag->phylink_config.supported_interfaces);
+
+	if (ag71xx_is(ag, QCA9550) && ag->mac_idx == 0)
+		__set_bit(PHY_INTERFACE_MODE_SGMII,
+			  ag->phylink_config.supported_interfaces);
+
+	if (ag71xx_is(ag, AR9340) && ag->mac_idx == 0)
+		__set_bit(PHY_INTERFACE_MODE_RMII,
+			  ag->phylink_config.supported_interfaces);
+
+	if ((ag71xx_is(ag, AR9340) && ag->mac_idx == 0) ||
+	    (ag71xx_is(ag, QCA9550) && ag->mac_idx == 1))
+		__set_bit(PHY_INTERFACE_MODE_RGMII,
+			  ag->phylink_config.supported_interfaces);
+
 	phylink = phylink_create(&ag->phylink_config, ag->pdev->dev.fwnode,
 				 ag->phy_if_mode, &ag71xx_phylink_mac_ops);
 	if (IS_ERR(phylink))

-- 
2.30.2

[PATCH net-next 2/3] net: ag71xx: remove interface checks in ag71xx_mac_validate()

From: Russell King (Oracle) <hidden>
Date: 2021-11-17 16:46:29

As phylink checks the interface mode against the supported_interfaces
bitmap, we no longer need to validate the interface mode, nor handle
PHY_INTERFACE_MODE_NA in the validation function. Remove these to
simplify the implementation.

Signed-off-by: Russell King (Oracle) <redacted>
---
 drivers/net/ethernet/atheros/ag71xx.c | 41 +--------------------------
 1 file changed, 1 insertion(+), 40 deletions(-)

diff --git a/drivers/net/ethernet/atheros/ag71xx.c b/drivers/net/ethernet/atheros/ag71xx.c
index 8d55ce266aa3..20c2cfdc30da 100644
--- a/drivers/net/ethernet/atheros/ag71xx.c
+++ b/drivers/net/ethernet/atheros/ag71xx.c

@@ -1028,42 +1028,8 @@ static void ag71xx_mac_validate(struct phylink_config *config,
 			    unsigned long *supported,
 			    struct phylink_link_state *state)
 {
-	struct ag71xx *ag = netdev_priv(to_net_dev(config->dev));
 	__ETHTOOL_DECLARE_LINK_MODE_MASK(mask) = { 0, };
 
-	switch (state->interface) {
-	case PHY_INTERFACE_MODE_NA:
-		break;
-	case PHY_INTERFACE_MODE_MII:
-		if ((ag71xx_is(ag, AR9330) && ag->mac_idx == 0) ||
-		    ag71xx_is(ag, AR9340) ||
-		    ag71xx_is(ag, QCA9530) ||
-		    (ag71xx_is(ag, QCA9550) && ag->mac_idx == 1))
-			break;
-		goto unsupported;
-	case PHY_INTERFACE_MODE_GMII:
-		if ((ag71xx_is(ag, AR9330) && ag->mac_idx == 1) ||
-		    (ag71xx_is(ag, AR9340) && ag->mac_idx == 1) ||
-		    (ag71xx_is(ag, QCA9530) && ag->mac_idx == 1))
-			break;
-		goto unsupported;
-	case PHY_INTERFACE_MODE_SGMII:
-		if (ag71xx_is(ag, QCA9550) && ag->mac_idx == 0)
-			break;
-		goto unsupported;
-	case PHY_INTERFACE_MODE_RMII:
-		if (ag71xx_is(ag, AR9340) && ag->mac_idx == 0)
-			break;
-		goto unsupported;
-	case PHY_INTERFACE_MODE_RGMII:
-		if ((ag71xx_is(ag, AR9340) && ag->mac_idx == 0) ||
-		    (ag71xx_is(ag, QCA9550) && ag->mac_idx == 1))
-			break;
-		goto unsupported;
-	default:
-		goto unsupported;
-	}
-
 	phylink_set(mask, MII);
 
 	phylink_set(mask, Pause);

@@ -1074,8 +1040,7 @@ static void ag71xx_mac_validate(struct phylink_config *config,
 	phylink_set(mask, 100baseT_Half);
 	phylink_set(mask, 100baseT_Full);
 
-	if (state->interface == PHY_INTERFACE_MODE_NA ||
-	    state->interface == PHY_INTERFACE_MODE_SGMII ||
+	if (state->interface == PHY_INTERFACE_MODE_SGMII ||
 	    state->interface == PHY_INTERFACE_MODE_RGMII ||
 	    state->interface == PHY_INTERFACE_MODE_GMII) {
 		phylink_set(mask, 1000baseT_Full);

@@ -1084,10 +1049,6 @@ static void ag71xx_mac_validate(struct phylink_config *config,
 
 	linkmode_and(supported, supported, mask);
 	linkmode_and(state->advertising, state->advertising, mask);
-
-	return;
-unsupported:
-	linkmode_zero(supported);
 }
 
 static void ag71xx_mac_pcs_get_state(struct phylink_config *config,

-- 
2.30.2

[PATCH net-next 3/3] net: ag71xx: use phylink_generic_validate()

From: Russell King (Oracle) <hidden>
Date: 2021-11-17 16:46:44

ag71xx apparently only supports MII port type, which makes it different
from other implementations. However, Oleksij says there is no special
reason for this.

Convert the driver to use phylink_generic_validate(), which will allow
all ethtool port linkmodes instead of only MII, giving the driver
consistent behaviour with other drivers.

Signed-off-by: Russell King (Oracle) <redacted>
---
 drivers/net/ethernet/atheros/ag71xx.c | 31 +++------------------------
 1 file changed, 3 insertions(+), 28 deletions(-)

diff --git a/drivers/net/ethernet/atheros/ag71xx.c b/drivers/net/ethernet/atheros/ag71xx.c
index 20c2cfdc30da..c747dc7984fd 100644
--- a/drivers/net/ethernet/atheros/ag71xx.c
+++ b/drivers/net/ethernet/atheros/ag71xx.c

@@ -1024,33 +1024,6 @@ static void ag71xx_mac_config(struct phylink_config *config, unsigned int mode,
 	ag71xx_wr(ag, AG71XX_REG_FIFO_CFG3, ag->fifodata[2]);
 }
 
-static void ag71xx_mac_validate(struct phylink_config *config,
-			    unsigned long *supported,
-			    struct phylink_link_state *state)
-{
-	__ETHTOOL_DECLARE_LINK_MODE_MASK(mask) = { 0, };
-
-	phylink_set(mask, MII);
-
-	phylink_set(mask, Pause);
-	phylink_set(mask, Asym_Pause);
-	phylink_set(mask, Autoneg);
-	phylink_set(mask, 10baseT_Half);
-	phylink_set(mask, 10baseT_Full);
-	phylink_set(mask, 100baseT_Half);
-	phylink_set(mask, 100baseT_Full);
-
-	if (state->interface == PHY_INTERFACE_MODE_SGMII ||
-	    state->interface == PHY_INTERFACE_MODE_RGMII ||
-	    state->interface == PHY_INTERFACE_MODE_GMII) {
-		phylink_set(mask, 1000baseT_Full);
-		phylink_set(mask, 1000baseX_Full);
-	}
-
-	linkmode_and(supported, supported, mask);
-	linkmode_and(state->advertising, state->advertising, mask);
-}
-
 static void ag71xx_mac_pcs_get_state(struct phylink_config *config,
 				     struct phylink_link_state *state)
 {

@@ -1124,7 +1097,7 @@ static void ag71xx_mac_link_up(struct phylink_config *config,
 }
 
 static const struct phylink_mac_ops ag71xx_phylink_mac_ops = {
-	.validate = ag71xx_mac_validate,
+	.validate = phylink_generic_validate,
 	.mac_pcs_get_state = ag71xx_mac_pcs_get_state,
 	.mac_an_restart = ag71xx_mac_an_restart,
 	.mac_config = ag71xx_mac_config,

@@ -1138,6 +1111,8 @@ static int ag71xx_phylink_setup(struct ag71xx *ag)
 
 	ag->phylink_config.dev = &ag->ndev->dev;
 	ag->phylink_config.type = PHYLINK_NETDEV;
+	ag->phylink_config.mac_capabilities = MAC_SYM_PAUSE | MAC_ASYM_PAUSE |
+		MAC_10 | MAC_100 | MAC_1000FD;
 
 	if ((ag71xx_is(ag, AR9330) && ag->mac_idx == 0) ||
 	    ag71xx_is(ag, AR9340) ||

-- 
2.30.2

Re: [PATCH net-next 0/3] net: ag71xx: phylink validate implementation updates

From: patchwork-bot+netdevbpf@kernel.org
Date: 2021-11-18 11:41:28

Hello:

This series was applied to netdev/net-next.git (master)
by David S. Miller [off-list ref]:

On Wed, 17 Nov 2021 16:45:57 +0000 you wrote:

Hi,

This series converts ag71xx to fill in the supported_interfaces member
of phylink_config, cleans up the validate() implementation, and then
converts to phylink_generic_validate().

The question over the port linkmode restriction has been answered by
Oleksij - there is no reason for this restriction, so we can go the
whole hog with this conversion. Thanks!

[...]

Here is the summary with links:
  - [net-next,1/3] net: ag71xx: populate supported_interfaces member
    https://git.kernel.org/netdev/net-next/c/680e9d2cd4bf
  - [net-next,2/3] net: ag71xx: remove interface checks in ag71xx_mac_validate()
    https://git.kernel.org/netdev/net-next/c/5e20a8aa48a0
  - [net-next,3/3] net: ag71xx: use phylink_generic_validate()
    https://git.kernel.org/netdev/net-next/c/c8fa4bac30e1

You are awesome, thank you!
-- 
Deet-doot-dot, I am a bot.
https://korg.docs.kernel.org/patchwork/pwbot.html

`h`	back out one level
`j`	next message in thread
`k`	previous message in thread
`l`	drill in
`Esc`	close help / fold thread tree
`?`	toggle this help