[PATCH net-next 03/12] ethernet: lpc: use eth_hw_addr_set()
From: Jakub Kicinski <kuba@kernel.org>
Date: 2021-10-18 14:31:13
Also in:
linux-arm-kernel
Subsystem:
arm/lpc32xx soc support, networking drivers, the rest · Maintainers:
Vladimir Zapolskiy, Piotr Wojtaszczyk, Andrew Lunn, "David S. Miller", Eric Dumazet, Jakub Kicinski, Paolo Abeni, Linus Torvalds
Commit 406f42fa0d3c ("net-next: When a bond have a massive amount
of VLANs...") introduced a rbtree for faster Ethernet address look
up. To maintain netdev->dev_addr in this tree we need to make all
the writes to it got through appropriate helpers.
Read the address into an array on the stack, then call
eth_hw_addr_set().
Signed-off-by: Jakub Kicinski <kuba@kernel.org>
---
CC: vz@mleia.com
CC: linux-arm-kernel@lists.infradead.org
---
drivers/net/ethernet/nxp/lpc_eth.c | 4 +++-
1 file changed, 3 insertions(+), 1 deletion(-)
diff --git a/drivers/net/ethernet/nxp/lpc_eth.c b/drivers/net/ethernet/nxp/lpc_eth.c
index fbfbf94e0377..a63cc295b979 100644
--- a/drivers/net/ethernet/nxp/lpc_eth.c
+++ b/drivers/net/ethernet/nxp/lpc_eth.c@@ -1232,6 +1232,7 @@ static int lpc_eth_drv_probe(struct platform_device *pdev) struct net_device *ndev; dma_addr_t dma_handle; struct resource *res; + u8 addr[ETH_ALEN]; int irq, ret; /* Setup network interface for RMII or MII mode */
@@ -1347,7 +1348,8 @@ static int lpc_eth_drv_probe(struct platform_device *pdev) pldat->phy_node = of_parse_phandle(np, "phy-handle", 0); /* Get MAC address from current HW setting (POR state is all zeros) */ - __lpc_get_mac(pldat, ndev->dev_addr); + __lpc_get_mac(pldat, addr); + eth_hw_addr_set(ndev, addr); if (!is_valid_ether_addr(ndev->dev_addr)) { of_get_ethdev_address(np, ndev);
--
2.31.1