[PATCH v6 net-next 06/10] net: dsa: microchip: add support for phylink management

@@ -393,6 +393,160 @@ int lan937x_internal_phy_read(struct ksz_device *dev, int addr, int reg,
 	return ksz_read16(dev, REG_VPHY_IND_DATA__2, val);
 }
 
+static void lan937x_config_gbit(struct ksz_device *dev, bool gbit, u8 *data)
+{
+	if (gbit)
+		*data &= ~PORT_MII_NOT_1GBIT;
+	else
+		*data |= PORT_MII_NOT_1GBIT;
+}
+
+static void lan937x_update_rgmii_tx_rx_delay(struct ksz_device *dev, int port,
+					     bool is_tx)
+{
+	struct ksz_port *p = &dev->ports[port];
+	u16 data16;
+	int reg;
+	u8 val;
+
+	if (is_tx) {
+		reg = REG_PORT_XMII_CTRL_5;
+		val = p->rgmii_tx_val;
+	} else {
+		reg = REG_PORT_XMII_CTRL_4;
+		val = p->rgmii_rx_val;
+	}
+
+	lan937x_pread16(dev, port, reg, &data16);
+
+	/* clear tune Adjust */
+	data16 &= ~PORT_TUNE_ADJ;
+	data16 |= (val << 7);
+	lan937x_pwrite16(dev, port, reg, data16);
+
+	data16 |= PORT_DLL_RESET;
+	/* write DLL reset to take effect */
+	lan937x_pwrite16(dev, port, reg, data16);
+}
+
+static void lan937x_apply_rgmii_delay(struct ksz_device *dev, int port, u8 val)
+{
+	struct ksz_port *p = &dev->ports[port];
+
+	/* Clear Ingress & Egress internal delay enabled bits */
+	val &= ~(PORT_RGMII_ID_EG_ENABLE | PORT_RGMII_ID_IG_ENABLE);
+
+	if (p->rgmii_tx_val) {
+		lan937x_update_rgmii_tx_rx_delay(dev, port, true);
+		dev_info(dev->dev, "Applied rgmii tx delay for the port %d\n",
+			 port);
+		val |= PORT_RGMII_ID_EG_ENABLE;
+	}
+
+	if (p->rgmii_rx_val) {
+		lan937x_update_rgmii_tx_rx_delay(dev, port, false);
+		dev_info(dev->dev, "Applied rgmii rx delay for the port %d\n",
+			 port);
+		val |= PORT_RGMII_ID_IG_ENABLE;
+	}
+
+	/* Enable RGMII internal delays */
+	lan937x_pwrite8(dev, port, REG_PORT_XMII_CTRL_1, val);
+}
+
+void lan937x_mac_config(struct ksz_device *dev, int port,
+			phy_interface_t interface)
+{
+	u8 data8;
+
+	lan937x_pread8(dev, port, REG_PORT_XMII_CTRL_1, &data8);
+
+	/* clear MII selection & set it based on interface later */
+	data8 &= ~PORT_MII_SEL_M;
+
+	/* configure MAC based on interface */
+	switch (interface) {
+	case PHY_INTERFACE_MODE_MII:
+		lan937x_config_gbit(dev, false, &data8);
+		data8 |= PORT_MII_SEL;
+		break;
+	case PHY_INTERFACE_MODE_RMII:
+		lan937x_config_gbit(dev, false, &data8);
+		data8 |= PORT_RMII_SEL;
+		break;
+	case PHY_INTERFACE_MODE_RGMII:
+		lan937x_config_gbit(dev, true, &data8);
+		data8 |= PORT_RGMII_SEL;
+		break;
+	case PHY_INTERFACE_MODE_RGMII_ID:
+	case PHY_INTERFACE_MODE_RGMII_TXID:
+	case PHY_INTERFACE_MODE_RGMII_RXID:
+		lan937x_config_gbit(dev, true, &data8);
+		data8 |= PORT_RGMII_SEL;
+
+		/* Apply rgmii internal delay for the mac */
+		lan937x_apply_rgmii_delay(dev, port, data8);
+
+		/* rgmii delay configuration is already applied above,
+		 * hence return from here as no changes required
+		 */
+		return;
+	default:
+		dev_err(dev->dev, "Unsupported interface '%s' for port %d\n",
+			phy_modes(interface), port);
+		return;
+	}
+
+	/* Write the updated value */
+	lan937x_pwrite8(dev, port, REG_PORT_XMII_CTRL_1, data8);
+}
+
+void lan937x_config_interface(struct ksz_device *dev, int port,
+			      int speed, int duplex,
+			      bool tx_pause, bool rx_pause)
+{
+	u8 xmii_ctrl0, xmii_ctrl1;
+
+	lan937x_pread8(dev, port, REG_PORT_XMII_CTRL_0, &xmii_ctrl0);
+	lan937x_pread8(dev, port, REG_PORT_XMII_CTRL_1, &xmii_ctrl1);
+
+	switch (speed) {
+	case SPEED_1000:
+		lan937x_config_gbit(dev, true, &xmii_ctrl1);
+		break;
+	case SPEED_100:
+		lan937x_config_gbit(dev, false, &xmii_ctrl1);
+		xmii_ctrl0 |= PORT_MAC_SPEED_100;
+		break;
+	case SPEED_10:
+		lan937x_config_gbit(dev, false, &xmii_ctrl1);
+		xmii_ctrl0 &= ~PORT_MAC_SPEED_100;
+		break;
+	default:
+		dev_err(dev->dev, "Unsupported speed on port %d: %d\n",
+			port, speed);
+		return;
+	}
+
+	if (duplex)
+		xmii_ctrl0 |= PORT_FULL_DUPLEX;
+	else
+		xmii_ctrl0 &= ~PORT_FULL_DUPLEX;
+
+	if (tx_pause)
+		xmii_ctrl0 |= PORT_TX_FLOW_CTRL;
+	else
+		xmii_ctrl1 &= ~PORT_TX_FLOW_CTRL;
+
+	if (rx_pause)
+		xmii_ctrl0 |= PORT_RX_FLOW_CTRL;
+	else
+		xmii_ctrl0 &= ~PORT_RX_FLOW_CTRL;
+
+	lan937x_pwrite8(dev, port, REG_PORT_XMII_CTRL_0, xmii_ctrl0);
+	lan937x_pwrite8(dev, port, REG_PORT_XMII_CTRL_1, xmii_ctrl1);
+}
+
 void lan937x_port_setup(struct ksz_device *dev, int port, bool cpu_port)
 {
 	struct ksz_port *p = &dev->ports[port];

@@ -33,6 +33,11 @@ void lan937x_cfg_port_member(struct ksz_device *dev, int port,
 			     u8 member);
 void lan937x_port_setup(struct ksz_device *dev, int port, bool cpu_port);
 int lan937x_enable_spi_indirect_access(struct ksz_device *dev);
+void lan937x_config_interface(struct ksz_device *dev, int port,
+			      int speed, int duplex,
+			      bool tx_pause, bool rx_pause);
+void lan937x_mac_config(struct ksz_device *dev, int port,
+			phy_interface_t interface);
 
 struct mib_names {
 	int index;

@@ -326,6 +326,100 @@ static int lan937x_get_max_mtu(struct dsa_switch *ds, int port)
 	return (FR_MAX_SIZE - VLAN_ETH_HLEN - ETH_FCS_LEN);
 }
 
+static void lan937x_phylink_mac_config(struct dsa_switch *ds, int port,
+				       unsigned int mode,
+				       const struct phylink_link_state *state)
+{
+	struct ksz_device *dev = ds->priv;
+
+	/* Internal PHYs */
+	if (lan937x_is_internal_phy_port(dev, port))
+		return;
+
+	if (phylink_autoneg_inband(mode)) {
+		dev_err(ds->dev, "In-band AN not supported!\n");
+		return;
+	}
+
+	lan937x_mac_config(dev, port, state->interface);
+}
+
+static void lan937x_phylink_mac_link_up(struct dsa_switch *ds, int port,
+					unsigned int mode,
+					phy_interface_t interface,
+					struct phy_device *phydev,
+					int speed, int duplex,
+					bool tx_pause, bool rx_pause)
+{
+	struct ksz_device *dev = ds->priv;
+
+	/* Internal PHYs */
+	if (lan937x_is_internal_phy_port(dev, port))
+		return;
+
+	if (phylink_autoneg_inband(mode)) {
+		dev_err(ds->dev, "In-band AN not supported!\n");
+		return;
+	}
+	lan937x_config_interface(dev, port, speed, duplex,
+				 tx_pause, rx_pause);
+}
+
+static void lan937x_phylink_validate(struct dsa_switch *ds, int port,
+				     unsigned long *supported,
+				     struct phylink_link_state *state)
+{
+	struct ksz_device *dev = ds->priv;
+	__ETHTOOL_DECLARE_LINK_MODE_MASK(mask) = { 0, };
+
+	/* Check for unsupported interfaces */
+	if (!phy_interface_mode_is_rgmii(state->interface) &&
+	    state->interface != PHY_INTERFACE_MODE_RMII &&
+	    state->interface != PHY_INTERFACE_MODE_MII &&
+	    state->interface != PHY_INTERFACE_MODE_NA &&
+	    state->interface != PHY_INTERFACE_MODE_INTERNAL) {
+		bitmap_zero(supported, __ETHTOOL_LINK_MODE_MASK_NBITS);
+		dev_err(ds->dev, "Unsupported interface '%s' for port %d\n",
+			phy_modes(state->interface), port);
+		return;
+	}
+
+	/* For RGMII, RMII, MII and internal TX phy port and
+	 * as per phylink.h, when @state->interface is %PHY_INTERFACE_MODE_NA,
+	 * phylink expects the MAC driver to return all supported link modes.
+	 */
+	if (phy_interface_mode_is_rgmii(state->interface) ||
+	    state->interface == PHY_INTERFACE_MODE_RMII ||
+	    state->interface == PHY_INTERFACE_MODE_MII ||
+	    state->interface == PHY_INTERFACE_MODE_NA ||
+	    lan937x_is_internal_base_tx_phy_port(dev, port)) {
+		phylink_set(mask, 10baseT_Half);
+		phylink_set(mask, 10baseT_Full);
+		phylink_set(mask, 100baseT_Half);
+		phylink_set(mask, 100baseT_Full);
+		phylink_set(mask, Autoneg);
+		phylink_set_port_modes(mask);
+		phylink_set(mask, Pause);
+		phylink_set(mask, Asym_Pause);
+	}
+
+	/* For RGMII interface */
+	if (phy_interface_mode_is_rgmii(state->interface) ||
+	    state->interface == PHY_INTERFACE_MODE_NA)
+		phylink_set(mask, 1000baseT_Full);
+
+	/* For T1 PHY */
+	if (lan937x_is_internal_base_t1_phy_port(dev, port) ||
+	    state->interface == PHY_INTERFACE_MODE_NA) {
+		phylink_set(mask, 100baseT1_Full);
+		phylink_set_port_modes(mask);
+	}
+
+	bitmap_and(supported, supported, mask, __ETHTOOL_LINK_MODE_MASK_NBITS);
+	bitmap_and(state->advertising, state->advertising, mask,
+		   __ETHTOOL_LINK_MODE_MASK_NBITS);
+}
+
 const struct dsa_switch_ops lan937x_switch_ops = {
 	.get_tag_protocol = lan937x_get_tag_protocol,
 	.setup = lan937x_setup,

@@ -338,6 +432,10 @@ const struct dsa_switch_ops lan937x_switch_ops = {
 	.port_fast_age = ksz_port_fast_age,
 	.port_max_mtu = lan937x_get_max_mtu,
 	.port_change_mtu = lan937x_change_mtu,
+	.phylink_validate = lan937x_phylink_validate,
+	.phylink_mac_link_down = ksz_mac_link_down,
+	.phylink_mac_config = lan937x_phylink_mac_config,
+	.phylink_mac_link_up = lan937x_phylink_mac_link_up,
 };
 
 int lan937x_switch_register(struct ksz_device *dev)