Re: [PATCH] net: phy: micrel: ksz9131 led errata workaround

Micrel KSZ9131 PHY LED behavior is not correct when configured in
Individual Mode, LED1 (Activity LED) is in the ON state when there is
no-link.

Workaround this by setting bit 9 of register 0x1e after verifying that
the LED configuration is Individual Mode.

This issue is described in KSZ9131RNX Silicon Errata DS80000693B
(http://ww1.microchip.com/downloads/en/DeviceDoc/80000863A.pdf) and
according to that it will not be corrected in a future silicon revision.

Signed-off-by: Francesco Dolcini <redacted>
---
 drivers/net/phy/micrel.c | 21 +++++++++++++++++++++
 1 file changed, 21 insertions(+)

diff --git a/drivers/net/phy/micrel.c b/drivers/net/phy/micrel.c
index c330a5a9f665..661dedec84c4 100644
--- a/drivers/net/phy/micrel.c
+++ b/drivers/net/phy/micrel.c

@@ -1003,6 +1003,23 @@ static int ksz9131_config_rgmii_delay(struct phy_device *phydev)
 			      txcdll_val);
 }
 
+/* Silicon Errata DS80000693B
+ *
+ * When LEDs are configured in Individual Mode, LED1 is ON in a no-link
+ * condition. Workaround is to set register 0x1e, bit 9, this way LED1 behaves
+ * according to the datasheet (off if there is no link).
+ */
+
+static int ksz9131_led_errata(struct phy_device *phydev)
+{
+	int ret = 0;
+
+	if (phy_read_mmd(phydev, 2, 0) & BIT(4))