Re: [PATCH] sfc: Export fibre-specific link modes for 1/10G

On Tue, Oct 19, 2021 at 05:31:52PM +0200, Andrew Lunn wrote:

On Mon, Oct 18, 2021 at 08:37:08PM +0200, Erik Ekman wrote:

quoted

These modes were added to ethtool.h in 5711a98221443 ("net: ethtool: add support
for 1000BaseX and missing 10G link modes") back in 2016.

Only setting CR mode for 10G, similar to how 25/40/50/100G modes are set up.

Tested using SFN5122F-R7 (with 2 SFP+ ports) and a 1000BASE-BX10 SFP module.

Did you test with a Copper SFP modules? 

quoted

+++ b/drivers/net/ethernet/sfc/mcdi_port_common.c

@@ -133,9 +133,9 @@ void mcdi_to_ethtool_linkset(u32 media, u32 cap, unsigned long *linkset)
 	case MC_CMD_MEDIA_QSFP_PLUS:
 		SET_BIT(FIBRE);
 		if (cap & (1 << MC_CMD_PHY_CAP_1000FDX_LBN))
-			SET_BIT(1000baseT_Full);
+			SET_BIT(1000baseX_Full);

I'm wondering if you should have both? The MAC is doing 1000BaseX. But
it could then be connected to a copper PHY which then does
1000baseT_Full? At 1G, it is however more likely to be using SGMII,
not 1000BaseX.

Yes, they should both be set. We actually did a 10Gbase-T version of Siena,
the SFN51x1T.

Martin