Re: [PATCH 1/2] mwifiex: Use non-posted PCI register writes

On 9/23/21 10:22 PM, Pali Rohár wrote:

On Thursday 23 September 2021 22:41:30 Andy Shevchenko wrote:

quoted

On Thu, Sep 23, 2021 at 6:28 PM Jonas Dreßler [off-list ref] wrote:

quoted

On 9/22/21 2:50 PM, Jonas Dreßler wrote:

...

quoted

- Just calling mwifiex_write_reg() once and then blocking until the card
wakes up using my delay-loop doesn't fix the issue, it's actually
writing multiple times that fixes the issue

These observations sound a lot like writes (and even reads) are actually
being dropped, don't they?

It sounds like you're writing into a not ready (fully powered on) device.

This reminds me a discussion with Bjorn about CRS response returned
after firmware crash / reset when device is not ready yet:
https://lore.kernel.org/linux-pci/20210922164803.GA203171@bhelgaas/ (local)

Could not be this similar issue? You could check it via reading
PCI_VENDOR_ID register from config space. And if it is not valid value
then card is not really ready yet.

quoted

To check this, try to put a busy loop for reading and check the value
till it gets 0.

Something like

   unsigned int count = 1000;

   do {
     if (mwifiex_read_reg(...) == 0)
       break;
   } while (--count);


-- 
With Best Regards,
Andy Shevchenko

I've tried both reading PCI_VENDOR_ID and the firmware status using a 
busy loop now, but sadly none of them worked. It looks like the card 
always replies with the correct values even though it sometimes won't 
wake up after that.

I do have one new observation though, although I've no clue what could 
be happening here: When reading PCI_VENDOR_ID 1000 times to wakeup we 
can "predict" the wakeup failure because exactly one (usually around the 
20th) of those 1000 reads will fail. Maybe the firmware actually tries 
to wake up, encounters an error somewhere in its wakeup routines and 
then goes down a special failure code path. That code path keeps the 
cards CPU so busy that at some point a PCI_VENDOR_ID request times out?

Or well, maybe the card actually wakes up fine, but we don't receive the 
interrupt on our end, so many possibilities...