Re: [PATCH V1 4/5] net: fec: add eee mode tx lpi support

On Fri, Jul 09, 2021 at 03:53:54PM +0800, Joakim Zhang wrote:

From: Fugang Duan <redacted>

The i.MX8MQ ENET version support IEEE802.3az eee mode, add
eee mode tx lpi enable to support ethtool interface.

usage:
1. set sleep and wake timer to 5ms:
ethtool --set-eee eth0 eee on tx-lpi on tx-timer 5000
2. check the eee mode:
~# ethtool --show-eee eth0
EEE Settings for eth0:
        EEE status: enabled - active
        Tx LPI: 5000 (us)
        Supported EEE link modes:  100baseT/Full
                                   1000baseT/Full
        Advertised EEE link modes:  100baseT/Full
                                    1000baseT/Full
        Link partner advertised EEE link modes:  100baseT/Full

Note: For realtime case and IEEE1588 ptp case, it should disable
EEE mode.

Signed-off-by: Fugang Duan <redacted>
Signed-off-by: Joakim Zhang <redacted>

This patch results in:

drivers/net/ethernet/freescale/fec_main.c: In function 'fec_enet_eee_mode_set':
drivers/net/ethernet/freescale/fec_main.c:2801:40: error: 'FEC_LPI_SLEEP' undeclared
drivers/net/ethernet/freescale/fec_main.c:2802:39: error: 'FEC_LPI_WAKE' undeclared

when building m68k:m5272c3_defconfig.

Guenter