[PATCH net-next v6 12/25] net: dsa: qca8k: limit port5 delay to qca8337
flat view
STALE1973d
REVIEWED: 8 (8M)
From: Ansuel Smith <ansuelsmth@gmail.com>
Date: 2021-05-14 21:01:36
Also in:
linux-devicetree, lkml
Subsystem:
networking drivers, networking [dsa], the rest · Maintainers:
Andrew Lunn, "David S. Miller", Eric Dumazet, Jakub Kicinski, Paolo Abeni, Andrew Lunn, Vladimir Oltean, Linus Torvalds
Revision v6 of 3 in this series; 1 review trailer (1 from subsystem maintainers).
Revisions (3)
- v1 [diff vs current]
- v5 [diff vs current]
- v6 current
Limit port5 rx delay to qca8337. This is taken from the legacy QSDK code that limits the rx delay on port5 to only this particular switch version, on other switch only the tx and rx delay for port0 are needed. Signed-off-by: Ansuel Smith <ansuelsmth@gmail.com> Reviewed-by: Andrew Lunn <andrew@lunn.ch> --- drivers/net/dsa/qca8k.c | 6 ++++-- 1 file changed, 4 insertions(+), 2 deletions(-)
diff --git a/drivers/net/dsa/qca8k.c b/drivers/net/dsa/qca8k.c
index 65f27d136aef..b598930190e1 100644
--- a/drivers/net/dsa/qca8k.c
+++ b/drivers/net/dsa/qca8k.c@@ -1003,8 +1003,10 @@ qca8k_phylink_mac_config(struct dsa_switch *ds, int port, unsigned int mode, QCA8K_PORT_PAD_RGMII_EN | QCA8K_PORT_PAD_RGMII_TX_DELAY(QCA8K_MAX_DELAY) | QCA8K_PORT_PAD_RGMII_RX_DELAY(QCA8K_MAX_DELAY)); - qca8k_write(priv, QCA8K_REG_PORT5_PAD_CTRL, - QCA8K_PORT_PAD_RGMII_RX_DELAY_EN); + /* QCA8337 requires to set rgmii rx delay */ + if (priv->switch_id == QCA8K_ID_QCA8337) + qca8k_write(priv, QCA8K_REG_PORT5_PAD_CTRL, + QCA8K_PORT_PAD_RGMII_RX_DELAY_EN); break; case PHY_INTERFACE_MODE_SGMII: case PHY_INTERFACE_MODE_1000BASEX:
--
2.30.2