[PATCH 5/5] docs: networking: device_drivers: fix bad usage of UTF-8 chars
From: Mauro Carvalho Chehab <mchehab+huawei@kernel.org>
Date: 2021-05-11 15:01:53
Also in:
intel-wired-lan, linux-doc, lkml
Subsystem:
documentation, intel ethernet drivers, networking [general], the rest · Maintainers:
Jonathan Corbet, Tony Nguyen, Przemek Kitszel, "David S. Miller", Eric Dumazet, Jakub Kicinski, Paolo Abeni, Linus Torvalds
Probably because the original file was pre-processed by some
tool, both i40e.rst and iavf.rst files are using this character:
- U+2013 ('–'): EN DASH
meaning an hyphen when calling a command line application, which
is obviously wrong. So, replace them by an hyphen, ensuring
that it will be properly displayed as literals when building
the documentation.
Signed-off-by: Mauro Carvalho Chehab <mchehab+huawei@kernel.org>
---
.../networking/device_drivers/ethernet/intel/i40e.rst | 4 ++--
.../networking/device_drivers/ethernet/intel/iavf.rst | 2 +-
2 files changed, 3 insertions(+), 3 deletions(-)
diff --git a/Documentation/networking/device_drivers/ethernet/intel/i40e.rst b/Documentation/networking/device_drivers/ethernet/intel/i40e.rst
index 8a9b18573688..2d3f6bd969a2 100644
--- a/Documentation/networking/device_drivers/ethernet/intel/i40e.rst
+++ b/Documentation/networking/device_drivers/ethernet/intel/i40e.rst@@ -173,7 +173,7 @@ Director rule is added from ethtool (Sideband filter), ATR is turned off by the driver. To re-enable ATR, the sideband can be disabled with the ethtool -K option. For example:: - ethtool –K [adapter] ntuple [off|on] + ethtool -K [adapter] ntuple [off|on] If sideband is re-enabled after ATR is re-enabled, ATR remains enabled until a TCP-IP flow is added. When all TCP-IP sideband rules are deleted, ATR is
@@ -688,7 +688,7 @@ shaper bw_rlimit: for each tc, sets minimum and maximum bandwidth rates. Totals must be equal or less than port speed. For example: min_rate 1Gbit 3Gbit: Verify bandwidth limit using network -monitoring tools such as ifstat or sar –n DEV [interval] [number of samples] +monitoring tools such as `ifstat` or `sar -n DEV [interval] [number of samples]` 2. Enable HW TC offload on interface::
diff --git a/Documentation/networking/device_drivers/ethernet/intel/iavf.rst b/Documentation/networking/device_drivers/ethernet/intel/iavf.rst
index 52e037b11c97..25330b7b5168 100644
--- a/Documentation/networking/device_drivers/ethernet/intel/iavf.rst
+++ b/Documentation/networking/device_drivers/ethernet/intel/iavf.rst@@ -179,7 +179,7 @@ shaper bw_rlimit: for each tc, sets minimum and maximum bandwidth rates. Totals must be equal or less than port speed. For example: min_rate 1Gbit 3Gbit: Verify bandwidth limit using network -monitoring tools such as ifstat or sar –n DEV [interval] [number of samples] +monitoring tools such as ``ifstat`` or ``sar -n DEV [interval] [number of samples]`` NOTE: Setting up channels via ethtool (ethtool -L) is not supported when the
--
2.30.2