Re: [RFC net-next] net: dsa: rtl8366rb: support bridge offloading

Use port isolation registers to configure bridge offloading.
Remove the VLAN init, as we have proper CPU tag and bridge offloading
support now.

Signed-off-by: DENG Qingfang <dqfext@gmail.com>
---
This is not tested, as I don't have a RTL8366RB board. And I think there
is potential race condition in port_bridge_{join,leave}.

 drivers/net/dsa/rtl8366rb.c | 73 ++++++++++++++++++++++++++++++++++---
 1 file changed, 67 insertions(+), 6 deletions(-)

diff --git a/drivers/net/dsa/rtl8366rb.c b/drivers/net/dsa/rtl8366rb.c
index a89093bc6c6a..9f6e2b361216 100644
--- a/drivers/net/dsa/rtl8366rb.c
+++ b/drivers/net/dsa/rtl8366rb.c

@@ -300,6 +300,12 @@
 #define RTL8366RB_INTERRUPT_STATUS_REG	0x0442
 #define RTL8366RB_NUM_INTERRUPT		14 /* 0..13 */
 
+/* Port isolation registers */
+#define RTL8366RB_PORT_ISO_BASE		0x0F08
+#define RTL8366RB_PORT_ISO(pnum)	(RTL8366RB_PORT_ISO_BASE + (pnum))
+#define RTL8366RB_PORT_ISO_EN		BIT(0)
+#define RTL8366RB_PORT_ISO_PORTS_MASK	GENMASK(7, 1)
+
 /* bits 0..5 enable force when cleared */
 #define RTL8366RB_MAC_FORCE_CTRL_REG	0x0F11
 

@@ -835,6 +841,15 @@ static int rtl8366rb_setup(struct dsa_switch *ds)
 	if (ret)
 		return ret;
 
+	/* Isolate user ports */
+	for (i = 0; i < RTL8366RB_PORT_NUM_CPU; i++) {
+		ret = regmap_write(smi->map, RTL8366RB_PORT_ISO(i),
+				   RTL8366RB_PORT_ISO_EN |
+				   BIT(RTL8366RB_PORT_NUM_CPU + 1));
+		if (ret)
+			return ret;
+	}
+
 	/* Set up the "green ethernet" feature */
 	ret = rtl8366rb_jam_table(rtl8366rb_green_jam,
 				  ARRAY_SIZE(rtl8366rb_green_jam), smi, false);

@@ -963,10 +978,6 @@ static int rtl8366rb_setup(struct dsa_switch *ds)
 			return ret;
 	}
 
-	ret = rtl8366_init_vlan(smi);
-	if (ret)
-		return ret;
-
 	ret = rtl8366rb_setup_cascaded_irq(smi);
 	if (ret)
 		dev_info(smi->dev, "no interrupt support\n");

@@ -977,8 +988,6 @@ static int rtl8366rb_setup(struct dsa_switch *ds)
 		return -ENODEV;
 	}
 
-	ds->configure_vlan_while_not_filtering = false;