On Wed, Mar 10, 2021 at 03:12:57PM +0100, Greg KH wrote:
On Wed, Mar 10, 2021 at 03:47:44PM +0200, Ioana Ciornei wrote:
quoted
On Wed, Mar 10, 2021 at 01:44:46PM +0100, Greg KH wrote:
quoted
On Wed, Mar 10, 2021 at 02:14:37PM +0200, Ioana Ciornei wrote:
quoted
From: Ioana Ciornei <ioana.ciornei@nxp.com>
This patch set adds support for Rx/Tx capabilities on DPAA2 switch port
interfaces as well as fixing up some major blunders in how we take care
of the switching domains. The last patch actually moves the driver out
of staging now that the minimum requirements are met.
I am sending this directly towards the net-next tree so that I can use
the rest of the development cycle adding new features on top of the
current driver without worrying about merge conflicts between the
staging and net-next tree.
The control interface is comprised of 3 queues in total: Rx, Rx error
and Tx confirmation. In this patch set we only enable Rx and Tx conf.
All switch ports share the same queues when frames are redirected to the
CPU. Information regarding the ingress switch port is passed through
frame metadata - the flow context field of the descriptor.
NAPI instances are also shared between switch net_devices and are
enabled when at least on one of the switch ports .dev_open() was called
and disabled when no switch port is still up.
Since the last version of this feature was submitted to the list, I
reworked how the switching and flooding domains are taken care of by the
driver, thus the switch is now able to also add the control port (the
queues that the CPU can dequeue from) into the flooding domains of a
port (broadcast, unknown unicast etc). With this, we are able to receive
and sent traffic from the switch interfaces.
Also, the capability to properly partition the DPSW object into multiple
switching domains was added so that when not under a bridge, the ports
are not actually capable to switch between them. This is possible by
adding a private FDB table per switch interface. When multiple switch
interfaces are under the same bridge, they will all use the same FDB
table.
Another thing that is fixed in this patch set is how the driver handles
VLAN awareness. The DPAA2 switch is not capable to run as VLAN unaware
but this was not reflected in how the driver responded to requests to
change the VLAN awareness. In the last patch, this is fixed by
describing the switch interfaces as Rx VLAN filtering on [fixed] and
declining any request to join a VLAN unaware bridge.
I'll take the first 14 patches now, and then you will have a "clean"
place to ask for the movement of this out of staging.
I was about to respond but it seems that you already applied them into
the staging tree. By the way, I was expecting a bit of review from the
netdev community since these changes are mainly to get the driver in a
proper state for the move.
They are only in my "testing" branch, I can easily drop them right now
if you want me to.
Well, it seems that I added some checks at the last minute, forgot to
compile-test patch by patch and the checks were added too early in the
series therefore it fails to build now on patches 10 and 11.
Could you please just drop this so that that I can respin them with that
addressed as well as any other review feedback?
Ioana