[PATCH v2] bcm63xx_enet: fix internal phy IRQ assignment

The current bcm63xx_enet driver doesn't asign the internal phy IRQ. As a
result of this it works in polling mode.

Fix it using the phy_device structure to assign the platform IRQ.

Tested under a BCM6348 board. Kernel dmesg before the patch:
   Broadcom BCM63XX (1) bcm63xx_enet-0:01: attached PHY driver [Broadcom
              BCM63XX (1)] (mii_bus:phy_addr=bcm63xx_enet-0:01, irq=POLL)

After the patch:
   Broadcom BCM63XX (1) bcm63xx_enet-0:01: attached PHY driver [Broadcom
              BCM63XX (1)] (mii_bus:phy_addr=bcm63xx_enet-0:01, irq=17)

Pluging and uplugging the ethernet cable now generates interrupts and the
PHY goes up and down as expected.

Signed-off-by: Daniel González Cabanelas <redacted>
---
changes in V2: 
  - snippet moved after the mdiobus registration
  - added missing brackets

 drivers/net/ethernet/broadcom/bcm63xx_enet.c | 13 +++++++++++--
 1 file changed, 11 insertions(+), 2 deletions(-)

diff --git a/drivers/net/ethernet/broadcom/bcm63xx_enet.c b/drivers/net/ethernet/broadcom/bcm63xx_enet.c
index fd876721316..dd218722560 100644
--- a/drivers/net/ethernet/broadcom/bcm63xx_enet.c
+++ b/drivers/net/ethernet/broadcom/bcm63xx_enet.c

@@ -1818,10 +1818,19 @@ static int bcm_enet_probe(struct platform_device *pdev)
 		 * if a slave is not present on hw */
 		bus->phy_mask = ~(1 << priv->phy_id);
 
-		if (priv->has_phy_interrupt)
+		ret = mdiobus_register(bus);
+
+		if (priv->has_phy_interrupt) {
+			phydev = mdiobus_get_phy(bus, priv->phy_id);
+			if (!phydev) {
+				dev_err(&dev->dev, "no PHY found\n");
+				goto out_unregister_mdio;
+			}
+
 			bus->irq[priv->phy_id] = priv->phy_interrupt;
+			phydev->irq = priv->phy_interrupt;
+		}
 
-		ret = mdiobus_register(bus);
 		if (ret) {
 			dev_err(&pdev->dev, "unable to register mdio bus\n");
 			goto out_free_mdio;

-- 
2.30.1