Re: [PATCH] net: mdiobus: Prevent spike on MDIO bus reset signal

On Tue, Jan 26, 2021 at 08:33:37AM +0100, Mike Looijmans wrote:

The mdio_bus reset code first de-asserted the reset by allocating with
GPIOD_OUT_LOW, then asserted and de-asserted again. In other words, if
the reset signal defaulted to asserted, there'd be a short "spike"
before the reset.

Instead, directly assert the reset signal using GPIOD_OUT_HIGH, this
removes the spike and also removes a line of code since the signal
is already high.

Hi Mike

This however appears to remove the reset pulse, if the reset line was
already low to start with. Notice you left

fsleep(bus->reset_delay_us);

without any action before it? What are we now waiting for?  Most data
sheets talk of a reset pulse. Take the reset line high, wait for some
time, take the reset low, wait for some time, and then start talking
to the PHY. I think with this patch, we have lost the guarantee of a
low to high transition.

Is this spike, followed by a pulse actually causing you problems? If
so, i would actually suggest adding another delay, to stretch the
spike. We have no control over the initial state of the reset line, it
is how the bootloader left it, we have to handle both states.

   Andrew