On 2020-12-15 18:23, Youghandhar Chintala wrote:

Currently in case of target hardware restart, we just reconfig and
re-enable the security keys and enable the network queues to start
data traffic back from where it was interrupted.

Many ath10k wifi chipsets have sequence numbers for the data
packets assigned by firmware and the mac sequence number will
restart from zero after target hardware restart leading to mismatch
in the sequence number expected by the remote peer vs the sequence
number of the frame sent by the target firmware.

This mismatch in sequence number will cause out-of-order packets
on the remote peer and all the frames sent by the device are dropped
until we reach the sequence number which was sent before we restarted
the target hardware

In order to fix this, we trigger a sta disconnect, for the targets
which expose this corresponding wiphy flag, in case of target hw
restart. After this there will be a fresh connection and thereby
avoiding the dropping of frames by remote peer.

The right fix would be to pull the entire data path into the host
which is not feasible or would need lots of complex changes and
will still be inefficient.

How about simply tracking which tids have aggregation enabled and send
DELBA frames for those after the restart?
It would mean less disruption for affected stations and less ugly hacks
in the stack for unreliable hardware.

- Felix