On 9/30/2020 12:09 PM, Andrew Lunn wrote:

On Wed, Sep 30, 2020 at 05:47:43PM +0800, Jisheng Zhang wrote:

quoted

Hi,

A GE phy supports pad isolation which can save power in WOL mode. But once the
isolation is enabled, the MAC can't send/receive pkts to/from the phy because
the phy is "isolated". To make the PHY work normally, I need to move the
enabling isolation to suspend hook, so far so good. But the isolation isn't
enabled in system shutdown case, to support this, I want to add shutdown hook
to net phy_driver, then also enable the isolation in the shutdown hook. Is
there any elegant solution?

quoted

Or we can break the assumption: ethernet can still send/receive pkts after
enabling WoL, no?

That is not an easy assumption to break. The MAC might be doing WOL,
so it needs to be able to receive packets.

What you might be able to assume is, if this PHY device has had WOL
enabled, it can assume the MAC does not need to send/receive after
suspend. The problem is, phy_suspend() will not call into the driver
is WOL is enabled, so you have no idea when you can isolate the MAC
from the PHY.

So adding a shutdown in mdio_driver_register() seems reasonable.  But
you need to watch out for ordering. Is the MDIO bus driver still
running?

If your Ethernet MAC controller implements a shutdown callback and that 
callback takes care of unregistering the network device which should 
also ensure that phy_disconnect() gets called, then your PHY's suspend 
function will be called.
-- 
Florian