Thread (9 messages) flat view 9 messages, 5 authors, 2020-05-08

Re: [PATCH net v2] net: bcmgenet: Clear ID_MODE_DIS in EXT_RGMII_OOB_CTRL when not needed

From: Stefan Wahren <wahrenst@gmx.net>
Date: 2020-05-08 17:26:47
Also in: lkml

Hi Marek,

Am 07.05.20 um 12:03 schrieb Marek Szyprowski:
Hi

On 07.05.2020 11:46, Marek Szyprowski wrote:
quoted
On 25.02.2020 14:11, Nicolas Saenz Julienne wrote:
quoted
Outdated Raspberry Pi 4 firmware might configure the external PHY as
rgmii although the kernel currently sets it as rgmii-rxid. This makes
connections unreliable as ID_MODE_DIS is left enabled. To avoid this,
explicitly clear that bit whenever we don't need it.

Fixes: da38802211cc ("net: bcmgenet: Add RGMII_RXID support")
Signed-off-by: Nicolas Saenz Julienne <redacted>
I've finally bisected the network issue I have on my RPi4 used for
testing mainline builds. The bisect pointed to this patch. Once it got
applied in v5.7-rc1, the networking is broken on my RPi4 in ARM32bit
mode and kernel compiled from bcm2835_defconfig. I'm using u-boot to
tftp zImage/dtb/initrd there. After reverting this patch network is
working fine again. The strange thing is that networking works fine if
kernel is compiled from multi_v7_defconfig but I don't see any obvious
difference there.

I'm not sure if u-boot is responsible for this break, but kernel
definitely should be able to properly reset the hardware to the valid
state.

I can provide more information, just let me know what is needed. Here
is the log, I hope it helps:

[   11.881784] bcmgenet fd580000.ethernet eth0: Link is Up -
1Gbps/Full - flow control off
[   11.889935] IPv6: ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready

root@target:~# ping host
PING host (192.168.100.1) 56(84) bytes of data.
From 192.168.100.53 icmp_seq=1 Destination Host Unreachable
...
Okay, I've played a bit more with this and found that enabling
CONFIG_BROADCOM_PHY fixes this network issue. I wonder if Genet driver
should simply select CONFIG_BROADCOM_PHY the same way as it selects
CONFIG_BCM7XXX_PHY.
thanks for finding this issue. So it seems arm64/defconfig is also affected.

I don't have a strong opinion how to solve this.

Best regards
Stefan
Best regards
Keyboard shortcuts
hback out one level
jnext message in thread
kprevious message in thread
ldrill in
Escclose help / fold thread tree
?toggle this help