Re: [PATCH v2 0/6] Add ACPI bindings to the genet

From: Florian Fainelli <f.fainelli@gmail.com>
Date: Mon, 24 Feb 2020 15:09:36 -0800

On 2/24/20 2:53 PM, Jeremy Linton wrote:

quoted

This patch series allows the BCM GENET, as used on the RPi4,
to attach when booted in an ACPI environment. The DSDT entry to
trigger this is seen below. Of note, the first patch adds a
small extension to the mdio layer which allows drivers to find
the mii_bus without firmware assistance. The fifth patch in
the set retrieves the MAC address from the umac registers
rather than carrying it directly in the DSDT. This of course
requires the firmware to pre-program it, so we continue to fall
back on a random one if it appears to be garbage.

Thanks for your persistence on this I was able to apply this to the
latest net-next tree and give this a spin on a STB chip (which uses DT)
and did not see any issues, so:

Tested-by: Florian Fainelli <f.fainelli@gmail.com>

Series applied, thanks everyone.