[PATCH net-next 1/2] net: dsa: felix: Handle PAUSE RX regardless of AN result
From: Vladimir Oltean <olteanv@gmail.com>
Date: 2020-01-16 18:19:46
Subsystem:
networking drivers, networking [dsa], ocelot ethernet switch driver, the rest · Maintainers:
Andrew Lunn, "David S. Miller", Eric Dumazet, Jakub Kicinski, Paolo Abeni, Vladimir Oltean, Linus Torvalds
From: Alex Marginean <redacted> Flow control is used with 2500Base-X and AQR PHYs to do rate adaptation between line side 100/1000 links and MAC running at 2.5G. This is independent of the flow control configuration settled on line side though AN. In general, allowing the MAC to handle flow control even if not negotiated with the link partner should not be a problem, so the patch just enables it in all cases. Signed-off-by: Alex Marginean <redacted> Signed-off-by: Vladimir Oltean <vladimir.oltean@nxp.com> --- drivers/net/dsa/ocelot/felix.c | 8 ++++++-- 1 file changed, 6 insertions(+), 2 deletions(-)
diff --git a/drivers/net/dsa/ocelot/felix.c b/drivers/net/dsa/ocelot/felix.c
index d6ee089dbfe1..46334436a8fe 100644
--- a/drivers/net/dsa/ocelot/felix.c
+++ b/drivers/net/dsa/ocelot/felix.c@@ -222,8 +222,12 @@ static void felix_phylink_mac_config(struct dsa_switch *ds, int port, * specification in incoming pause frames. */ mac_fc_cfg = SYS_MAC_FC_CFG_FC_LINK_SPEED(state->speed); - if (state->pause & MLO_PAUSE_RX) - mac_fc_cfg |= SYS_MAC_FC_CFG_RX_FC_ENA; + + /* handle Rx pause in all cases, with 2500base-X this is used for rate + * adaptation. + */ + mac_fc_cfg |= SYS_MAC_FC_CFG_RX_FC_ENA; + if (state->pause & MLO_PAUSE_TX) mac_fc_cfg |= SYS_MAC_FC_CFG_TX_FC_ENA | SYS_MAC_FC_CFG_PAUSE_VAL_CFG(0xffff) |
--
2.17.1