Hi Jiaxun,

thanks for your patch.

On Wed, Oct 30, 2019 at 09:53:46PM +0800, Jiaxun Yang wrote:

This binding will provide extra information for PCI enabled
device.

Signed-off-by: Jiaxun Yang <jiaxun.yang@flygoat.com>

Please verify the bindings using dtbs_check as described in
Documentation/devicetree/writing-schema.rst

The id does not match the filename of the schema.

i.e. the above should be:

	$id: http://devicetree.org/schemas/net/wireless/loongson,pci-gmac.yaml#

+$schema: http://devicetree.org/meta-schemas/core.yaml#
+
+title: Loongson PCI GMAC Device Tree Bindings
+
+allOf:
+  - $ref: "snps,dwmac.yaml#"

snps,dwmac.yaml# is in the parent directory relative to loongson,pci-gmac.yaml.
So I think the above needs to be:

	$ref: "../snps,dwmac.yaml#"

+
+maintainers:
+  - Jiaxun Yang [off-list ref]
+
+properties:
+  compatible:
+    const: loongson,pci-gmac
+
+  reg:
+    maxItems: 1
+
+  interrupts:
+    minItems: 1
+    maxItems: 3
+    items:
+      - description: Combined signal for various interrupt events
+      - description: The interrupt to manage the remote wake-up packet detection
+      - description: The interrupt that occurs when Rx exits the LPI state
+
+  interrupt-names:
+    minItems: 1
+    maxItems: 3
+    items:
+      - const: macirq
+      - const: eth_wake_irq
+      - const: eth_lpi
+
+  clocks:
+    items:
+      - description: GMAC main clock
+
+  clock-names:
+    items:
+      - const: stmmaceth
+
+required:
+  - compatible
+  - reg
+  - interrupts
+  - interrupt-names
+  - clocks
+  - clock-names
+  - phy-mode
+
+examples:
+  - |
+    gmac: ethernet@ {

I would have expected a bus address here, f.e.:

	gmac: ethernet@0x00001800

+        compatible = "loongson,pci-irq";
+        reg = <0x00001800 0 0 0 0>;

I think there is one to many cell in the above, perhaps it should be.

	reg = <0x00001800 0 0 0>;

Also, I would expect the registers to be wider than 0, i.e. no registers.

`

+        interrupts = <12>, <13>;
+        interrupt-names = "macirq", "eth_lpi";
+        clocks =  <&clk_pch_gmac>;
+        clock-names = "stmmaceth";
+        phy-mode = "rgmii";
+    };
+
+# FIXME: We should set it, but it would report all the generic
+# properties as additional properties.
+# additionalProperties: false
+
+...
-- 
2.23.0