Re: [PATCH spi for-5.4 0/5] Deterministic SPI latency with NXP DSPI driver

On Wed, Aug 21, 2019 at 11:17:23PM +0300, Vladimir Oltean wrote:

Of course PPS with a dedicated hardware receiver that can take input
compare timestamps is always preferable. However non-Ethernet
synchronization in the field looks to me like "make do with whatever
you can". I'm not sure a plain GPIO that raises an interrupt is better
than an interrupt-driven serial protocol controller - it's (mostly)
the interrupts that throw off the precision of the software timestamp.
And use Miroslav's pps-gpio-poll module and you're back from where you
started (try to make a sw timestamp as precise as possible).

Right, it might be better, might not.  You can consider hacking a
local time stamp into the ISR.  Also, if one of your MACs has a input
event pin, you can feed the switch's PPS output in there.

wouldn't be my first choice. But DSA could have that built-in, and
with the added latency benefit of a MAC-to-MAC connection.
Too bad the mv88e6xxx driver can't do loopback timestamping, that's
already 50% of the DSA drivers that support PTP at all. An embedded
solution for this is less compelling now.

Let me back track on my statement about mv88e6xxx.  At the time, I
didn't see any practical way to use the CPU port for synchronization,
but I forget exactly the details.  Maybe it is indeed possible,
somehow.  If you can find a way that will work on your switch and on
the Marvell, then I'd like to hear about it.

Thinking back...

One problem is this.  PTP requires a delay measurement.  You can send
a delay request from the host, but there will never be a reply.

Another problem is this.  A Sync message arriving on an external port
is time stamped there, but then it is encapsulated as a tagged DSA
management message and delivered out the CPU port.  At this point, it
is no longer a PTP frame and will not be time stamped at the CPU port
on egress.

Thanks,
Richard