[PATCH AUTOSEL 5.1 071/375] net: phy: improve genphy_soft_reset

From: Heiner Kallweit <hkallweit1@gmail.com>

[ Upstream commit 8c90b795e90f7753d23c18e8b95dd71b4a18c5d9 ]

PHY's behave differently when being reset. Some reset registers to
defaults, some don't. Some trigger an autoneg restart, some don't.

So let's also set the autoneg restart bit when resetting. Then PHY
behavior should be more consistent. Clearing BMCR_ISOLATE serves the
same purpose and is borrowed from genphy_restart_aneg.

BMCR holds the speed / duplex settings in fixed mode. Therefore
we may have an issue if a soft reset resets BMCR to its default.
So better call genphy_setup_forced() afterwards in fixed mode.
We've seen no related complaint in the last >10 yrs, so let's
treat it as an improvement.

Signed-off-by: Heiner Kallweit <hkallweit1@gmail.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
Signed-off-by: Sasha Levin <sashal@kernel.org>
---
 drivers/net/phy/phy_device.c | 16 ++++++++++++++--
 1 file changed, 14 insertions(+), 2 deletions(-)

diff --git a/drivers/net/phy/phy_device.c b/drivers/net/phy/phy_device.c
index cd5966b0db571..f6a6cc5bf118d 100644
--- a/drivers/net/phy/phy_device.c
+++ b/drivers/net/phy/phy_device.c

@@ -1829,13 +1829,25 @@ EXPORT_SYMBOL(genphy_read_status);
  */
 int genphy_soft_reset(struct phy_device *phydev)
 {
+	u16 res = BMCR_RESET;
 	int ret;
 
-	ret = phy_set_bits(phydev, MII_BMCR, BMCR_RESET);
+	if (phydev->autoneg == AUTONEG_ENABLE)
+		res |= BMCR_ANRESTART;
+
+	ret = phy_modify(phydev, MII_BMCR, BMCR_ISOLATE, res);
 	if (ret < 0)
 		return ret;
 
-	return phy_poll_reset(phydev);
+	ret = phy_poll_reset(phydev);
+	if (ret)
+		return ret;
+
+	/* BMCR may be reset to defaults */
+	if (phydev->autoneg == AUTONEG_DISABLE)
+		ret = genphy_setup_forced(phydev);
+
+	return ret;
 }
 EXPORT_SYMBOL(genphy_soft_reset);
 

-- 
2.20.1