[PATCH net-next v2 09/15] net: mvpp2: always disable both MACs when disabling a port
From: Antoine Tenart <hidden>
Date: 2019-03-01 10:55:28
Also in:
lkml
Subsystem:
marvell mvpp2 ethernet driver, networking drivers, the rest · Maintainers:
Marcin Wojtas, Russell King, Andrew Lunn, "David S. Miller", Eric Dumazet, Jakub Kicinski, Paolo Abeni, Linus Torvalds
This patch modifies the port_disable() helper to always disable both the GMAC and the XLG MAC when called. At boot time we do not know of a port was enabled in the firmware/bootloader, and if so what mode was used (hence which of the two MACs was used). This also help in implementing a logic where all blocks are disabled when not used, and only enabled regarding the current mode used on a given port. Signed-off-by: Antoine Tenart <redacted> --- drivers/net/ethernet/marvell/mvpp2/mvpp2_main.c | 8 ++++---- 1 file changed, 4 insertions(+), 4 deletions(-)
diff --git a/drivers/net/ethernet/marvell/mvpp2/mvpp2_main.c b/drivers/net/ethernet/marvell/mvpp2/mvpp2_main.c
index 11284918d907..b27966355df9 100644
--- a/drivers/net/ethernet/marvell/mvpp2/mvpp2_main.c
+++ b/drivers/net/ethernet/marvell/mvpp2/mvpp2_main.c@@ -1214,11 +1214,11 @@ static void mvpp2_port_disable(struct mvpp2_port *port) /* Disable & reset should be done separately */ val &= ~MVPP22_XLG_CTRL0_MAC_RESET_DIS; writel(val, port->base + MVPP22_XLG_CTRL0_REG); - } else { - val = readl(port->base + MVPP2_GMAC_CTRL_0_REG); - val &= ~(MVPP2_GMAC_PORT_EN_MASK); - writel(val, port->base + MVPP2_GMAC_CTRL_0_REG); } + + val = readl(port->base + MVPP2_GMAC_CTRL_0_REG); + val &= ~(MVPP2_GMAC_PORT_EN_MASK); + writel(val, port->base + MVPP2_GMAC_CTRL_0_REG); } /* Set IEEE 802.3x Flow Control Xon Packet Transmission Mode */
--
2.20.1