[PATCH 2/2] arm64: dts: clearfog-gt-8k: 1G eth PHY reset signal
From: Baruch Siach <baruch@tkos.co.il>
Date: 2018-10-16 10:50:53
Also in:
linux-arm-kernel
Subsystem:
arm/marvell kirkwood and armada 370, 375, 38x, 39x, xp, 3700, 7k/8k, cn9130 soc support, the rest · Maintainers:
Andrew Lunn, Gregory Clement, Sebastian Hesselbarth, Linus Torvalds
This reset signal controls the Marvell 1512 1G PHY. Note that current implementation queries the PHY over the MDIO bus (get_phy_device() call from of_mdiobus_register_phy()) before reset signal deassert. If the PHY reset signal is asserted at boot time, PHY registration fails. So current code relies on the bootloader to deassert the reset signal. Signed-off-by: Baruch Siach <baruch@tkos.co.il> --- arch/arm64/boot/dts/marvell/armada-8040-clearfog-gt-8k.dts | 4 ++++ 1 file changed, 4 insertions(+)
diff --git a/arch/arm64/boot/dts/marvell/armada-8040-clearfog-gt-8k.dts b/arch/arm64/boot/dts/marvell/armada-8040-clearfog-gt-8k.dts
index af1310c53bc8..73df0ef5e0c4 100644
--- a/arch/arm64/boot/dts/marvell/armada-8040-clearfog-gt-8k.dts
+++ b/arch/arm64/boot/dts/marvell/armada-8040-clearfog-gt-8k.dts@@ -337,6 +337,10 @@ */ marvell,reg-init = <3 16 0 0x1017>; reg = <0>; + pinctrl-names = "default"; + pinctrl-0 = <&cp0_copper_eth_phy_reset>; + reset-gpios = <&cp1_gpio1 11 GPIO_ACTIVE_LOW>; + reset-assert-us = <10000>; }; switch0: switch0@4 {
--
2.19.1