[PATCH v1 net-next] stmmac: fix DMA channel hang in half-duplex mode
From: Bhadram Varka <hidden>
Date: 2018-06-13 04:30:58
Subsystem:
networking drivers, stmmac ethernet driver, the rest · Maintainers:
Andrew Lunn, "David S. Miller", Eric Dumazet, Jakub Kicinski, Paolo Abeni, Maxime Chevallier, Linus Torvalds
HW does not support Half-duplex mode in multi-queue scenario. Fix it by not advertising the Half-Duplex mode if multi-queue enabled. Signed-off-by: Bhadram Varka <redacted> --- drivers/net/ethernet/stmicro/stmmac/stmmac_main.c | 10 ++++++++++ 1 file changed, 10 insertions(+)
diff --git a/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c b/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c
index 11fb7c7..07e748c 100644
--- a/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c
+++ b/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c@@ -928,6 +928,7 @@ static void stmmac_check_pcs_mode(struct stmmac_priv *priv) static int stmmac_init_phy(struct net_device *dev) { struct stmmac_priv *priv = netdev_priv(dev); + u32 tx_cnt = priv->plat->tx_queues_to_use; struct phy_device *phydev; char phy_id_fmt[MII_BUS_ID_SIZE + 3]; char bus_id[MII_BUS_ID_SIZE];
@@ -969,6 +970,15 @@ static int stmmac_init_phy(struct net_device *dev) SUPPORTED_1000baseT_Full); /* + * Half-duplex mode not supported with multiqueue + * half-duplex can only works with single queue + */ + if (tx_cnt > 1) + phydev->supported &= ~(SUPPORTED_1000baseT_Half | + SUPPORTED_100baseT_Half | + SUPPORTED_10baseT_Half); + + /* * Broken HW is sometimes missing the pull-up resistor on the * MDIO line, which results in reads to non-existent devices returning * 0 rather than 0xffff. Catch this here and treat 0 as a non-existent
--
2.7.4