Re: [PATCH 1/4] arcnet: com20020: Add com20020 io mapped version

On 05/17/2018 10:31 PM, David Miller wrote:

From: Andrea Greco <redacted>
Date: Thu, 17 May 2018 15:05:29 +0200

quoted

+ /* Will be set by userspace during if setup */
+ dev->dev_addr[0] = 0;

Hmmm... really?

Also, every error path from this point forward will leak 'dev'.

In com20020.c found this:
/* FIXME: do this some other way! */
if (!dev->dev_addr[0])
dev->dev_addr[0] = arcnet_inb(ioaddr, 8);

NODE-ID, must be univoque, for all arcnet network.
My previews idea was take random value but, this could create a
collision over network.

A possible solution is:
In case of collision com20020 set a bit in status register.
Then peak a new NODE-ID and repeat this while correct NODE-ID is found.

Other ideas is pass it via DTS.
But suppose have 2 same product in same network, same address same problem.
For this reason i prefer left standard driver behavior.

Other ideas for solve this ?

Other question discussed with Tobin in RFC patch is:

At now a devm_ioremap is done by this driver.

Other version of this driver, PCI, PCMCIA, ISA do not remap memory.
Other implementation, use:inb outb for r/w operation.
I do a ugly #ifndef and redefine arcnet_inb in case is defined
CONFIG_ARCNET_COM20020_IO.

My proposal was:
Add relative callback arcnet_inb, arcnet_outb and friends hw struct in
arcdevice.h, then every driver set callback with required function.

Regards, Andrea