Re: [PATCH v3] net: phy: DP83TC811: Introduce support for the DP83TC811 phy

Andrew

On 05/11/2018 01:30 PM, Andrew Lunn wrote:

On Fri, May 11, 2018 at 01:08:19PM -0500, Dan Murphy wrote:

quoted

Add support for the DP83811 phy.

The DP83811 supports both rgmii and sgmii interfaces.
There are 2 part numbers for this the DP83TC811R does not
reliably support the SGMII interface but the DP83TC811S will.

There is not a way to differentiate these parts from the
hardware or register set.  So this is controlled via the DT
to indicate which phy mode is required.  Or the part can be
strapped to a certain interface.

Data sheet can be found here:
http://www.ti.com/product/DP83TC811S-Q1/description
http://www.ti.com/product/DP83TC811R-Q1/description

Signed-off-by: Dan Murphy <redacted>

Hi Dan

It is normal to add any Reviewed-by, or Tested-by: tags you received,
so long as you don't make major changes.

Thanks for the reminder.

I usually add them if I get them explicitly stated in the review.

I have not seen any Reviewed-by or Tested-by tags in any of the replies for the
patch.  But I may have missed it.

Dan

    Andrew

-- 
------------------
Dan Murphy