[PATCH 2/8] batman-adv: Disable CONFIG_BATMAN_ADV_DEBUGFS by default
From: Simon Wunderlich <sw@simonwunderlich.de>
Date: 2018-05-24 12:03:05
Also in:
batman
Subsystem:
batman advanced, the rest · Maintainers:
Marek Lindner, Simon Wunderlich, Antonio Quartulli, Sven Eckelmann, Linus Torvalds
From: Sven Eckelmann <sven@narfation.org> All tools which were known to the batman-adv development team are supporting the batman-adv netlink interface since a while. Also debugfs is not supported for batman-adv interfaces in any non-default netns. Thus disabling CONFIG_BATMAN_ADV_DEBUGFS by default should not cause problems on most systems. It is still possible to enable it in case it is still required in a specific setup. Signed-off-by: Sven Eckelmann <sven@narfation.org> Signed-off-by: Simon Wunderlich <sw@simonwunderlich.de> --- net/batman-adv/Kconfig | 4 ++-- 1 file changed, 2 insertions(+), 2 deletions(-)
diff --git a/net/batman-adv/Kconfig b/net/batman-adv/Kconfig
index e4e2e02b7380..bee034a95208 100644
--- a/net/batman-adv/Kconfig
+++ b/net/batman-adv/Kconfig@@ -94,13 +94,13 @@ config BATMAN_ADV_DEBUGFS bool "batman-adv debugfs entries" depends on BATMAN_ADV depends on DEBUG_FS - default y + default n help Enable this to export routing related debug tables via debugfs. The information for each soft-interface and used hard-interface can be found under batman_adv/ - If unsure, say Y. + If unsure, say N. config BATMAN_ADV_DEBUG bool "B.A.T.M.A.N. debugging"
--
2.11.0