[PATCH net] net: stmmac: First Queue must always be in DCB mode
From: Jose Abreu <Jose.Abreu@synopsys.com>
Date: 2017-10-26 09:07:35
Also in:
lkml
Subsystem:
networking drivers, stmmac ethernet driver, the rest · Maintainers:
Andrew Lunn, "David S. Miller", Eric Dumazet, Jakub Kicinski, Paolo Abeni, Maxime Chevallier, Linus Torvalds
According to DWMAC databook the first queue operating mode must always be in DCB. As MTL_QUEUE_DCB = 1, we need to always set the first queue operating mode to DCB otherwise driver will think that queue is in AVB mode (because MTL_QUEUE_AVB = 0). Signed-off-by: Jose Abreu <redacted> Cc: Joao Pinto <redacted> Cc: David S. Miller <davem@davemloft.net> Cc: Giuseppe Cavallaro <redacted> Cc: Alexandre Torgue <redacted> --- drivers/net/ethernet/stmicro/stmmac/stmmac_platform.c | 7 +++++++ 1 file changed, 7 insertions(+)
diff --git a/drivers/net/ethernet/stmicro/stmmac/stmmac_platform.c b/drivers/net/ethernet/stmicro/stmmac/stmmac_platform.c
index 21f59fe..603225b 100644
--- a/drivers/net/ethernet/stmicro/stmmac/stmmac_platform.c
+++ b/drivers/net/ethernet/stmicro/stmmac/stmmac_platform.c@@ -150,6 +150,13 @@ static void stmmac_mtl_setup(struct platform_device *pdev, plat->rx_queues_to_use = 1; plat->tx_queues_to_use = 1; + /* First Queue must always be in DCB mode. As MTL_QUEUE_DCB = 1 we need + * to always set this, otherwise Queue will be classified as AVB + * (because MTL_QUEUE_AVB = 0). + */ + plat->rx_queues_cfg[0].mode_to_use = MTL_QUEUE_DCB; + plat->tx_queues_cfg[0].mode_to_use = MTL_QUEUE_DCB; + rx_node = of_parse_phandle(pdev->dev.of_node, "snps,mtl-rx-config", 0); if (!rx_node) return;
--
1.9.1