Thread (1 message) 1 message, 1 author, 2017-09-04

Re: [PATCH v3 2/3] dt-binding: net: sfp binding documentation

From: Sergei Shtylyov <hidden>
Date: 2017-09-04 09:59:29
Also in: linux-devicetree

Hello!

On 9/3/2017 3:31 PM, Baruch Siach wrote:
Add device-tree binding documentation SFP transceivers. Support for SFP
transceivers has been recently introduced (drivers/net/phy/sfp.c).

Signed-off-by: Baruch Siach <redacted>
[...]
quoted hunk
diff --git a/Documentation/devicetree/bindings/net/sff,sfp.txt b/Documentation/devicetree/bindings/net/sff,sfp.txt
new file mode 100644
index 000000000000..b98ee5945265
--- /dev/null
+++ b/Documentation/devicetree/bindings/net/sff,sfp.txt
@@ -0,0 +1,78 @@
+Small Form Factor (SFF) Committee Small Form-factor Pluggable (SFP)
+Transceiver
+
+Required properties:
+
+- compatible : must be "sff,sfp"
+
+Optional Properties:
+
+- i2c-bus : phandle of an I2C bus controller for the SFP two wire serial
+  interface
+
+- moddef0-gpios : GPIO phandle and a single specifier of the MOD-DEF0 (AKA
    There's always a single specifier following a phandle, tho it may have 
different # of cells, no need to spell that out.
+  Mod_ABS) module presence input gpio signal, active (module absent) high
+
+- los-gpios : GPIO phandle and a single specifier of the Receiver Loss of
    Same here.
+  Signal Indication input gpio signal, active (signal lost) high
+
+- tx-fault-gpios : GPIO phandle and a single specifier of the Module
    And here.
+  Transmitter Fault input gpio signal, active (fault condition) high
+
+- tx-disable-gpios : GPIO phandle and a single specifier of the Transmitter
    And here.
+  Disable output gpio signal, active (Tx disable) high
+
+- rate-select0-gpios : GPIO phandle and a single specifier of the Rx Signaling
    Here too.
+  Rate Select (AKA RS0) output gpio signal, low: low Rx rate, high: high Rx
+  rate
+
+- rate-select1-gpios : GPIO phandle and a single specifier of the Tx Signaling
    Here ass well.
+  Rate Select (AKA RS1) output gpio signal (SFP+ only), low: low Tx rate,
+  high: high Tx rate
+
[...]

MBR, Sergei
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo-u79uwXL29TY76Z2rM5mHXA@public.gmane.org
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Keyboard shortcuts
hback out one level
jnext message in thread
kprevious message in thread
ldrill in
Escclose help / fold thread tree
?toggle this help