[PATCH v5 3/5] stmmac: pci: Make stmmac_pci_find_phy_addr truly generic
From: Jan Kiszka <jan.kiszka@siemens.com>
Date: 2017-06-22 06:18:18
Also in:
lkml
Subsystem:
networking drivers, stmmac ethernet driver, the rest · Maintainers:
Andrew Lunn, "David S. Miller", Eric Dumazet, Jakub Kicinski, Paolo Abeni, Linus Torvalds
From: Jan Kiszka <jan.kiszka@siemens.com> Move the special case for the early Galileo firmware into quark_default_setup. This allows to use stmmac_pci_find_phy_addr for non-quark cases. Signed-off-by: Jan Kiszka <jan.kiszka@siemens.com> Reviewed-by: Andy Shevchenko <redacted> --- drivers/net/ethernet/stmicro/stmmac/stmmac_pci.c | 20 +++++++++++++------- 1 file changed, 13 insertions(+), 7 deletions(-)
diff --git a/drivers/net/ethernet/stmicro/stmmac/stmmac_pci.c b/drivers/net/ethernet/stmicro/stmmac/stmmac_pci.c
index d3d74e526e17..f44ae49eb11c 100644
--- a/drivers/net/ethernet/stmicro/stmmac/stmmac_pci.c
+++ b/drivers/net/ethernet/stmicro/stmmac/stmmac_pci.c@@ -51,12 +51,8 @@ static int stmmac_pci_find_phy_addr(struct pci_dev *pdev, unsigned int func = PCI_FUNC(pdev->devfn); struct stmmac_pci_dmi_data *dmi; - /* - * Galileo boards with old firmware don't support DMI. We always return - * 1 here, so at least first found MAC controller would be probed. - */ if (!name) - return 1; + return -ENODEV; for (dmi = info->dmi; dmi->name && *dmi->name; dmi++) { if (!strcmp(dmi->name, name) && dmi->func == func) {
@@ -136,8 +132,18 @@ static int quark_default_data(struct pci_dev *pdev, * does not connect to any PHY interface. */ ret = stmmac_pci_find_phy_addr(pdev, info); - if (ret < 0) - return ret; + if (ret < 0) { + /* Return error to the caller on DMI enabled boards. */ + if (dmi_get_system_info(DMI_BOARD_NAME)) + return ret; + + /* + * Galileo boards with old firmware don't support DMI. We always + * use 1 here as PHY address, so at least the first found MAC + * controller would be probed. + */ + ret = 1; + } plat->bus_id = PCI_DEVID(pdev->bus->number, pdev->devfn); plat->phy_addr = ret;
--
2.12.3