Re: Setting link down or up in software

On Thu, 2017-01-12 at 16:28 +0100, Andrew Lunn wrote:

quoted

Here's an example of "Link is Down" printed when I set link up:

At [   62.750220] I run ip link set dev eth0 down
Then leave the system idle for 10 minutes.
At [  646.263041] I run ip link set dev eth0 up
At [  647.364079] it prints "Link is Down"
At [  649.417434] it prints "Link is Up - 1Gbps/Full - flow control
rx/tx"

Purely a guess, but when you up the interface, it starts auto
negotiation. That often involves resetting the PHY. If the PHY has
already once completed autoneg, e.g. because of the boot loader, it
will be initially UP. The reset will put it DOWN, and then once
autoneg is complete, it will be Up again.

Pure guess. Go read the code and see if i'm write.

Historically, !IFF_UP meant the phy could be powered down or go into
some kind of low-power mode where link negotiation and communication
was unavailable.  Some drivers implemented that, some keep the PHY up
because who knows why, or because they just never got around to real
power management.

Dan