Hi Andrew,
Thank you for review and valuable comments.
Thanks,
Raju.
On Tue, Sep 27, 2016 at 04:16:33PM +0200, Andrew Lunn wrote:
EXTERNAL EMAIL
quoted
index 0000000..7ba3855
--- /dev/null
+++ b/Documentation/devicetree/bindings/net/mscc-phy-vsc8531.txt
@@ -0,0 +1,61 @@
+* Microsemi - vsc8531 Giga bit ethernet phy
+
+Required properties:
+- compatible : Should contain phy id as "ethernet-phy-idAAAA.BBBB"
+ If the phy's identifier is known then the list may contain an entry
+ of the form: "ethernet-phy-idAAAA.BBBB" where
+ AAAA - The value of the 16 bit Phy Identifier 1 register as
+ 4 hex digits. This is the chip vendor OUI bits 3:18
+ BBBB - The value of the 16 bit Phy Identifier 2 register as
+ 4 hex digits. This is the chip vendor OUI bits 19:24,
+ followed by 10 bits of a vendor specific ID.
+- reg : The ID number for the phy, usually a small integer
Please don't copy phy.txt. Just refer to it. Use text like:
The PHY device uses the binding described in
Documentation/devicetree/bindings/net/phy.txt
It may additionally have the following properties
Accepted.
quoted
+Optional properties:
+- vsc8531,edge-rate : Edge rate sets the drive strength of the MAC
+ interface output signals. Changing the drive
+ strength will affect the edge rate of the output
+ signal.
Are we specifying a rate or a strength? It is called edge-rate, so it
expect it to be a rate, mV/pS or something similar.
Accepted.
Andrew