Re: [PATCH 2/2] net: ethernet: marvell: pxa168_eth: use phy_ethtool_{get|set}_link_ksettings

On 07/17/2016 02:30 PM, Philippe Reynes wrote:

There are two generics functions phy_ethtool_{get|set}_link_ksettings,
so we can use them instead of defining the same code in the driver.

Signed-off-by: Philippe Reynes <redacted>
---
-	cmd.phy_address = pep->phy_addr;
-	cmd.speed = pep->phy_speed;
-	cmd.duplex = pep->phy_duplex;
-	cmd.advertising = PHY_BASIC_FEATURES;
-	cmd.autoneg = AUTONEG_ENABLE;
+	cmd.base.phy_address = pep->phy_addr;
+	cmd.base.speed = pep->phy_speed;
+	cmd.base.duplex = pep->phy_duplex;
+	ethtool_convert_legacy_u32_to_link_mode(cmd.link_modes.advertising,
+						PHY_BASIC_FEATURES);
+	cmd.base.autoneg = AUTONEG_ENABLE;
 
-	if (cmd.speed != 0)
-		cmd.autoneg = AUTONEG_DISABLE;
+	if (cmd.base.speed != 0)
+		cmd.base.autoneg = AUTONEG_DISABLE;
 
-	return pxa168_set_settings(dev, &cmd);
+	return phy_ethtool_set_link_ksettings(dev, &cmd);

This duplicates quite a bit of code that the core PHYLIB already deals
with, you should plan for a subsequent cleanup patch which removes all
of this.
-- 
Florian