Re: [PATCH net-next 1/5] net: dsa: b53: Add support for Broadcom RoboSwitch

+static void b53_switch_reset_gpio(struct b53_device *dev)
+{
+	int gpio = dev->reset_gpio;
+
+	if (gpio < 0)
+		return;
+
+	/* Reset sequence: RESET low(50ms)->high(20ms)
+	 */
+	gpio_set_value(gpio, 0);
+	mdelay(50);
+
+	gpio_set_value(gpio, 1);
+	mdelay(20);
+
+	dev->current_page = 0xff;
+}

Hi Florian

It would be better to use the gpiod API here, so the active hi/active
low flag is respected.

+	dev->reset_gpio = b53_switch_get_reset_gpio(dev);
+	if (dev->reset_gpio >= 0) {
+		ret = devm_gpio_request_one(dev->dev, dev->reset_gpio,
+					    GPIOF_OUT_INIT_HIGH, "robo_reset");
+		if (ret)
+			return ret;
+	}
+
+	return 0;
+}

+static inline int b53_switch_get_reset_gpio(struct b53_device *dev)
+{
+	enum bcm47xx_board board = bcm47xx_board_get();
+
+	switch (board) {
+	case BCM47XX_BOARD_LINKSYS_WRT300NV11:
+	case BCM47XX_BOARD_LINKSYS_WRT310NV1:
+		return 8;

Rather than hard coding it, could we get it from device tree?

       Andrew