Hi,

2016-03-18 17:00 GMT+01:00 Chen-Yu Tsai [off-list ref]:

Hi,

On Fri, Mar 18, 2016 at 11:37 PM, Alexandre TORGUE
[off-list ref] wrote:

quoted

Signed-off-by: Alexandre TORGUE <redacted>

diff --git a/Documentation/devicetree/bindings/net/stm32-dwmac.txt b/Documentation/devicetree/bindings/net/stm32-dwmac.txt
new file mode 100644
index 0000000..ada2aa4
--- /dev/null
+++ b/Documentation/devicetree/bindings/net/stm32-dwmac.txt

@@ -0,0 +1,32 @@
+STMicroelectronics STM32 / MCU DWMAC glue layer controller
+
+This file documents platform glue layer for stmmac.
+Please see stmmac.txt for the other unchanged properties.
+
+The device node has following properties.
+
+Required properties:
+- compatible:  Should be "st,stm32-dwmac" to select glue, and
+              "snps,dwmac-3.50a" to select IP vesrion.

If you need have sort of hardware glue, then it is not compatible.

We could have the case where the glue is set by a bootloader.
In this case, we will select IP version in compatible and we will use
generic dwmac glue to probe stmmac driver.

Regards

Alex.

ChenYu

quoted

+- clocks: Must contain a phandle for each entry in clock-names.
+- clock-names: Should be "stmmaceth" for the host clock.
+              Should be "tx-clk" for the MAC TX clock.
+              Should be "rx-clk" for the MAC RX clock.
+- st,syscon : Should be phandle/offset pair. The phandle to the syscon node which
+             encompases the glue register, and the offset of the control register.
+Example:
+
+               ethernet0: dwmac@40028000 {
+                       compatible = "st,stm32-dwmac", "snps,dwmac-3.50a";
+                       status = "disabled";
+                       reg = <0x40028000 0x8000>;
+                       reg-names = "stmmaceth";
+                       interrupts = <0 61 0>, <0 62 0>;
+                       interrupt-names = "macirq", "eth_wake_irq";
+                       clock-names = "stmmaceth", "tx-clk", "rx-clk";
+                       clocks = <&rcc 0 25>, <&rcc 0 26>, <&rcc 0 27>;
+                       st,syscon = <&syscfg 0x4>;
+                       snps,pbl = <8>;
+                       snps,mixed-burst;
+                       dma-ranges;
+               };
--
1.9.1


_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel