Re: question about vrf-lite

On 1/6/16 2:53 AM, roy.qing.li@gmail.com wrote:

Hi David Ahern:

when I test vrf-lite, I meet a question, could you help me?

the envirnment is below:
                                                  N2
            N1 (all configs here)          +---------------+
     +--------------+                      |               |
     |              |                      |               |
     |eth0 :10.0.2.1+----------------------+eth0 :10.0.2.2 |
     |              |                      +---------------+
     | VRF 1        |
     | table 5      |
     |              |
     +---------------+
     |              |
     | VRF 2        |                             N3
     | table 6      |                      +---------------+
     |              |                      |               |
     |eth1 :10.0.2.1+----------------------+eth0 :10.0.2.2 |
     +--------------+                      +---------------+

and configuration on N1 is below:

ip link add vrf1 type vrf table 5
ip link add vrf2 type vrf table 6
ip rule add pref 200 oif vrf1 lookup 5
ip rule add pref 200 iif vrf1 lookup 5
ip rule add pref 200 oif vrf2 lookup 6
ip rule add pref 200 iif vrf2 lookup 6
ip link set vrf1 up
ip link set vrf2 up
ip link set eth0 master vrf1
ip link set eth1 master vrf2

the route information is below:

# ip route get 10.0.2.2 oif vrf1
10.0.2.2 dev eth0  table 5  src 10.0.2.1
     cache
#
# ip route get 10.0.2.2 oif vrf2
10.0.2.2 dev eth1  table 6  src 10.0.2.1
     cache
#
#uname -r
4.4.0-rc5
#

when run the ping with different interfaces on N1, I expect
"ping -I vrf1 10.0.2.2" send to/receive from packets with N2,
"ping -I vrf2 10.0.2.2" send to/receive from packets with N3,

but I found whether the interface is vrf1 or vrf2, the packets always
is sent out through eth0, N2 reply; and no packets sent out through
eth1.

is it right?

no. The above works fine for me. I literally copied and pasted all of 
the commands except the master ones which were adapted to my setup -- 
eth9 and eth11 for me instead of eth0 and eth1. tcpdump on N2, N3 show 
the right one is receiving packets based on which 'ping -I vrf<N>' is run.

Do tables 5 and 6 have the right routes?