于 2015年03月03日 04:32, John Heffner 写道:

On Mon, Mar 2, 2015 at 4:29 AM, Fan Du[off-list ref]  wrote:

quoted

quoted

Timeout indicates search_high should be set to the new mtu corresponding to
current_mss no
matter how we change search_low. So the best shot here IMO would be updating
search_high
with current_mss, which in return makes the search window*slide*  from right
to left, and
the probing will converge in good speed eventually.

So my thoughts is:

@@ -113,6 +113,7 @@ static void tcp_mtu_probing(struct inet_connection_sock

*icsk, struct sock *sk)
                        struct tcp_sock *tp = tcp_sk(sk);
                        int mss;

+                       icsk_mtup.search_high = tcp_mss_to_mtu(sk,
tcp_current_mss(sk));
                        mss = tcp_mtu_to_mss(sk, icsk->icsk_mtup.search_low)

quoted

quoted

quoted

quoted

1;

                        mss = min(net->ipv4.sysctl_tcp_base_mss, mss);
                        mss = max(mss, 68 - tp->tcp_header_len);

Search_high should be adjusted downward only when you're quite certain
that you've gotten a negative signal.  There are many possible reasons
for successive timeouts including intermittent disconnection, and they
should not have a persistent (or very long-term) effect on MTU.  Leave
search_high where it is until a working MTU can be established, then
probe upward until probing can give you confidence you've found a new
ceiling, or gotten back to the old one.

If you think the current approach is broken, it would help to see a
concrete demonstration of how it's deficient (a real packet trace is
good!), and how a different approach work better.

 > With original approach(doubling mss), mss is not in between search_low and search_high,
 > it always equates search_low(subtract headers), the potential mss in case of blackhole
 > is 256 and 128, after doubling, it will become 512 and 256 eventually no matter how
 > route changes, even mtu reduced from 1500 to 1100 in intermediate node.

As for above statement, my test scenario is simple, using vxlan tunnel to connect two
docker instances on two hosts. All mtu default to 1500, run iperf between docker instances.
After the connection is setup, adjust the iperf sender host physical eth0 mtu to
1100, and after a couple of seconds, mss will be set to 512.

And after using binary search, actually, search_high will be set to probe_size trigger from
tcp_fastretrans_alert by my investigation. So the searching window does slide to left, thus
I will drop this patch. Maybe this is because my test method is not practical. And I believe
what you said about:

There are many possible reasons for successive timeouts including intermittent disconnection,

 > and they should not have a persistent (or very long-term) effect on MTU.

Never mind, no matter whether to adjust search_high, the reprobe timer will restore search_high
to maximum allowed, and once again, new mss will be available.

I will resend the rest of patches after incorporating your comments for reviewing.
Thanks for your feedback.