[RFT/RFC PATCH 0/8] net: dsa: mv88e6xxx: Add support for HW bridging
flat view
STALE4250d
From: Guenter Roeck <linux@roeck-us.net>
Date: 2015-02-23 19:38:53
Also in:
lkml
Subsystem:
networking drivers, networking [dsa], the rest · Maintainers:
Andrew Lunn, "David S. Miller", Eric Dumazet, Jakub Kicinski, Paolo Abeni, Andrew Lunn, Vladimir Oltean, Linus Torvalds
This patch series applies on top of net-next, plus Florian's patches integrating dsa with SWITCHDEV for HW bridging. It also requires the patch 'net: dsa: Ensure that port array elements are initialized before being used'. HW bridging support is currently only enabled for MV8865352, but it should be straightforward to enable support for other Marvell chips by adding three lines of initialization code to the respective source; see patch 8/8 for details. mv886e3131.c would also have to use mv88e6xxx_setup_port_common(). Patches 1-3 prepare the mv88e6xxx code for adding HW bridging support. Patch 4 adds core HW bridging support to the mv88e6xxx code. Patch 5-7 prepare the drivers for mv88e6352, mv88e6123_61_65, and mv88e6171 for HW bridging support, without actually enabling it. Patch 8 enables HW bridging support in the mv88e6352 driver. Patches 5 and 8 could possibly be merged, but I thought it was better to keep them separate because they logically serve a different purpose. Testing has been minimal, and only with MV88E6352. Ports can be added to and removed from a bridge, and I have been able to pass data through a port configured as bridge port.