Re: [PATCH v5 1/4] ethernet: arc: Add support for Rockchip SoC layer device tree bindings

On Wed, Sep 03, 2014 at 04:52:42PM +0000, Romain Perier wrote:

This patch defines a platform glue layer for Rockchip SoCs which
support arc-emac driver. It ensures that regulator for the rmii is on
before trying to connect to the ethernet controller. It applies right
speed and mode changes to the grf when ethernet settings change.

Hi Romain,

on a Radxa Rock when I try to remove the emac_rockchip module the
board locks up when calling clk_disable_unprepare(priv->refclk). The
tree is a net-next + your series, I don't know if I need some other
patches.

There is also the following build warning due to the emac dependency
on REGULATOR which in principle seems correct, but looking at other
drivers I wonder why they use the regulator APIs but don't have the
same dependency.

drivers/regulator/Kconfig:1:error: recursive dependency detected!
drivers/regulator/Kconfig:1:       symbol REGULATOR is selected by MDIO_SUN4I
drivers/net/phy/Kconfig:159:       symbol MDIO_SUN4I depends on PHYLIB
drivers/net/phy/Kconfig:5:         symbol PHYLIB is selected by ARC_EMAC_CORE
drivers/net/ethernet/arc/Kconfig:20:      symbol ARC_EMAC_CORE is selected by EMAC_ROCKCHIP
drivers/net/ethernet/arc/Kconfig:35:      symbol EMAC_ROCKCHIP depends on REGULATOR

Regards,
Beniamino