[PATCH net-next v2 4/4] be2net: re-enable vlan filtering mode asap
STALE4473d
From: Sathya Perla <hidden>
Date: 2014-06-30 07:29:08
Subsystem:
emulex 10gbps nic be2, be3-r, lancer, skyhawk-r driver (be2net), networking drivers, the rest · Maintainers:
Ajit Khaparde, Sriharsha Basavapatna, Andrew Lunn, "David S. Miller", Eric Dumazet, Jakub Kicinski, Paolo Abeni, Linus Torvalds
Revision v2 of 13 in this series.
Revisions (13)
From: Kalesh AP <redacted> While adding vlans, when the HW limit of vlan filters is reached, the driver enables vlan promiscuous mode. Similarily, while removing vlans, the driver must re-enable HW filtering as soon as the number of vlan filters is within the HW limit. Signed-off-by: Kalesh AP <redacted> Signed-off-by: Sathya Perla <redacted> --- drivers/net/ethernet/emulex/benet/be_main.c | 13 ++++--------- 1 files changed, 4 insertions(+), 9 deletions(-)
diff --git a/drivers/net/ethernet/emulex/benet/be_main.c b/drivers/net/ethernet/emulex/benet/be_main.c
index 5ac9d13..64a0b6c 100644
--- a/drivers/net/ethernet/emulex/benet/be_main.c
+++ b/drivers/net/ethernet/emulex/benet/be_main.c@@ -1172,20 +1172,15 @@ static int be_vlan_add_vid(struct net_device *netdev, __be16 proto, u16 vid) static int be_vlan_rem_vid(struct net_device *netdev, __be16 proto, u16 vid) { struct be_adapter *adapter = netdev_priv(netdev); - int status = 0; /* Packets with VID 0 are always received by Lancer by default */ if (lancer_chip(adapter) && vid == 0) - goto ret; + return 0; clear_bit(vid, adapter->vids); - status = be_vid_config(adapter); - if (!status) - adapter->vlans_added--; - else - set_bit(vid, adapter->vids); -ret: - return status; + adapter->vlans_added--; + + return be_vid_config(adapter); } static void be_clear_promisc(struct be_adapter *adapter)
--
1.7.1