[PATCH] mlx4: set carrier off after register netdev

ifconfig mlx4_en port reported RUNNING even though the link was down.

mlx4_en_init_netdev didn't initialize the dev operstate properly so
the operstate stayed as default IF_OPER_UNKNOWN, then ifconfig treated
the UNKNOWN as RUNNING state for backward compatiblity per RFC2863.

The fix calls netif_carrier_off which is supposed to set operstate
after register_netdev. Calling it before register_netdev has no effect
since the dev->state is still NETREG_UNINITIALIZED

Tested by removing the physical link signal to the mellanox 10G port,
modprobe mlx4_en, then ifconfig up. Verify there is no RUNNING status.

Signed-off-by: Min Zhang <redacted>
---
 drivers/net/ethernet/mellanox/mlx4/en_netdev.c |    2 +-
 1 files changed, 1 insertions(+), 1 deletions(-)

diff --git a/drivers/net/ethernet/mellanox/mlx4/en_netdev.c b/drivers/net/ethernet/mellanox/mlx4/en_netdev.c
index c96113b..8c562f7a 100644
--- a/drivers/net/ethernet/mellanox/mlx4/en_netdev.c
+++ b/drivers/net/ethernet/mellanox/mlx4/en_netdev.c

@@ -1306,12 +1306,12 @@ int mlx4_en_init_netdev(struct mlx4_en_dev *mdev, int port,
 
 	mdev->pndev[port] = dev;
 
-	netif_carrier_off(dev);
 	err = register_netdev(dev);
 	if (err) {
 		mlx4_err(mdev, "Netdev registration failed for port %d\n", port);
 		goto out;
 	}
+	netif_carrier_off(dev);
 
 	en_warn(priv, "Using %d TX rings\n", prof->tx_ring_num);
 	en_warn(priv, "Using %d RX rings\n", prof->rx_ring_num);

-- 
1.7.7.4