Re: [PATCH 00/13] drivers: hv: kvp

On Tue, 2012-07-03 at 15:24 +0000, KY Srinivasan wrote:

quoted

-----Original Message-----
From: Ben Hutchings [mailto:ben@decadent.org.uk]
Sent: Monday, July 02, 2012 3:57 PM
To: KY Srinivasan
Cc: Olaf Hering; Greg KH; apw@canonical.com; devel@linuxdriverproject.org;
virtualization@lists.osdl.org; linux-kernel@vger.kernel.org;
netdev@vger.kernel.org
Subject: Re: [PATCH 00/13] drivers: hv: kvp

On Mon, Jul 02, 2012 at 03:22:25PM +0000, KY Srinivasan wrote:

quoted

quoted

-----Original Message-----
From: Olaf Hering [mailto:olaf@aepfle.de]
Sent: Thursday, June 28, 2012 10:24 AM
To: KY Srinivasan
Cc: Greg KH; apw@canonical.com; devel@linuxdriverproject.org;
virtualization@lists.osdl.org; linux-kernel@vger.kernel.org
Subject: Re: [PATCH 00/13] drivers: hv: kvp

On Tue, Jun 26, KY Srinivasan wrote:

quoted

quoted

From: Greg KH [mailto:gregkh@linuxfoundation.org]
The fact that it was Red Hat specific was the main part, this should be
done in a standard way, with standard tools, right?

The reason I asked this question was to make sure I address these
issues in addition to whatever I am debugging now. I use the standard
tools and calls to retrieve all the IP configuration. As I look at
each distribution the files they keep persistent IP configuration
Information is different and that is the reason I chose to start with
RedHat. If there is a standard way to store the configuration, I will
do that.

KY,

instead of using system() in kvp_get_ipconfig_info and kvp_set_ip_info,
wouldnt it be easier to call an external helper script which does all
the distribution specific work? Just define some API to pass values to
the script, and something to read values collected by the script back
into the daemon.

On the "Get" side I mostly use standard commands/APIs to get all the

information:

quoted

1) IP address information and subnet mask: getifaddrs()
2) DNS information:  Parsing /etc/resolv.conf
3) /sbin/ip command for all the routing information

If you're interested in the *current* configuration then (1) and (3)
are OK but you should really use the rtnetlink API.

However, I suspect that Hyper-V assumes that current and persistent
configuration are the same thing, which is obviously not true in
general on Linux.  But if NetworkManager is running then you can
assume they are.

I am only interested in the currently active information. Why do you
recommend the use of rtnetlink API over the "ip" command. If I am not
mistaken, the ip command uses netlink to get the information. 

[...]

'Screen-scraping' the output of administrative tools is not good
practice.  It may be the best you can do when writing a shell script,
but for a C program it's generaly less reliable and often more difficult
than using the underlying C API.

Ben.

-- 
Ben Hutchings
73.46% of all statistics are made up.