Thread (4 messages) flat view 4 messages, 2 authors, 2012-07-24

Re: [BUG] tg3: frequent freezes

From: Eric Dumazet <hidden>
Date: 2012-07-24 04:56:44

On Mon, 2012-07-23 at 17:13 -0700, Michael Chan wrote:
On Mon, 2012-07-16 at 23:56 -0700, Michael Chan wrote: 
quoted
On Tue, 2012-07-17 at 07:35 +0200, Eric Dumazet wrote:
quoted
[  266.248330] tg3 0000:09:00.0: eth0: 0x00004800: 0x080303fe,
0x00000010, 0x00000000, 0x00000020
RDMAC_STATUS (0x4804) is showing 0x10 which is parity error.
quoted
[  266.247878] tg3 0000:09:00.0: eth0: 0x00000000: 0x167314e4,
0x40100506, 0x02000002, 0x00000010
PCI Status (0x06) is also showing SERR (0x4000)

Assuming your chip is not a bad chip, I'll have to look around for a
5755M and see if I can duplicate the problem.
Hi Eric, I found the same 5755m NIC as yours but I couldn't duplicate
any problems.  I ran netperf in a loop and it was running fine.

Here's my device and it should be identical to yours:

tg3.c:v3.123 (March 21, 2012)
tg3 0000:20:00.0: eth0: Tigon3 [partno(BCM95755m) rev a002] (PCI Express) MAC address 00:10:18:00:00:00
tg3 0000:20:00.0: eth0: attached PHY is 5755 (10/100/1000Base-T Ethernet) (WireSpeed[1], EEE[0])
tg3 0000:20:00.0: eth0: RXcsums[1] LinkChgREG[0] MIirq[0] ASF[0] TSOcap[1]
tg3 0000:20:00.0: eth0: dma_rwctrl[76180000] dma_mask[64-bit]
OK, thanks for testing !

Then I assume the hardware has some defect, maybe too high
temperature...
Keyboard shortcuts
hback out one level
jnext message in thread
kprevious message in thread
ldrill in
Escclose help / fold thread tree
?toggle this help