[PATCH net-next V2 5/8] net/mlx4_core: Do not reset module-parameter num_vfs when fail to enable sriov
From: Or Gerlitz <hidden>
Date: 2012-05-15 20:35:15
Subsystem:
mellanox mlx4 core vpi driver, networking drivers, the rest · Maintainers:
Tariq Toukan, Andrew Lunn, "David S. Miller", Eric Dumazet, Jakub Kicinski, Paolo Abeni, Linus Torvalds
From: Jack Morgenstein <redacted> Consider the following scenario: 2 HCAs, where only one of which can run SRIOV. If we reset the module parameter, all the VFs of the SRIOV HCA will be claimed by the PPF host (-- the code relies on num_vfs being non-zero to avoid this claiming, and num_vfs was reset when pci_enable_sriov failed for the non-SRIOV HCA). The solution is not to touch the num_vfs parameter. Also, eliminate the unneeded check of num_vfs when disabling sriov (the dev flag bit is sufficient). Signed-off-by: Jack Morgenstein <redacted> Signed-off-by: Or Gerlitz <redacted> --- drivers/net/ethernet/mellanox/mlx4/main.c | 5 ++--- 1 files changed, 2 insertions(+), 3 deletions(-)
diff --git a/drivers/net/ethernet/mellanox/mlx4/main.c b/drivers/net/ethernet/mellanox/mlx4/main.c
index 8bb05b4..8eed1f2 100644
--- a/drivers/net/ethernet/mellanox/mlx4/main.c
+++ b/drivers/net/ethernet/mellanox/mlx4/main.c@@ -1865,7 +1865,6 @@ static int __mlx4_init_one(struct pci_dev *pdev, const struct pci_device_id *id) mlx4_err(dev, "Failed to enable sriov," "continuing without sriov enabled" " (err = %d).\n", err); - num_vfs = 0; err = 0; } else { mlx4_warn(dev, "Running in master mode\n");
@@ -2022,7 +2021,7 @@ err_cmd: mlx4_cmd_cleanup(dev); err_sriov: - if (num_vfs && (dev->flags & MLX4_FLAG_SRIOV)) + if (dev->flags & MLX4_FLAG_SRIOV) pci_disable_sriov(pdev); err_rel_own:
@@ -2099,7 +2098,7 @@ static void mlx4_remove_one(struct pci_dev *pdev) if (dev->flags & MLX4_FLAG_MSI_X) pci_disable_msix(pdev); - if (num_vfs && (dev->flags & MLX4_FLAG_SRIOV)) { + if (dev->flags & MLX4_FLAG_SRIOV) { mlx4_warn(dev, "Disabling sriov\n"); pci_disable_sriov(pdev); }
--
1.7.1