Re: [E1000-devel] e1000e interface hang on 82574L

On 19 Mar 2012, Carolyn Wyborny said:

quoted

you'll see that I tested that, and it doesn't work :( even if it did
work, it shouldn't be needed: the driver attempts to turn off PCIe ASPM
on affected NICs, and fails, apparently because *something* turns it
back on again.

The driver attempts to disable L0s state, not the entire feature. It

It tries to disable L1 state as well (or it did when I tested this last,
although I suspect you're right and it may leave L1 turned on these
days: judging by the contents of e1000_82574_info, anyway.)

is also required that the device upstream on the bus from the 82574L
have this disabled. Yes, I agree there appears to be something in the
os that either ren-enables or fails to disable the feature on the
upstream device, as desired. Platforms/systems also appear to vary in
this regard, so the solutions may vary a bit as well.

Its worth trying your solution as well if what I suggested doesn't
work, but there is not one solution that fits all, unfortunately.

I don't *have* a solution. :( 'setpci by hand some unknown amount of
time after booting once the interface has stabilized' hardly counts as a
solution of any sort. It's, at best, a workaround that lets me use my
systems without hourly lockups until a real solution is found.

(To clarify: manual setpci to force off the ASPM bits is the only thing
that works for me. The driver's automatic disabling of L0s and L1
doesn't work: nor does booting with pcie_aspm=off. In both cases, I end
up with both L0s and L1 turned on, and a lockup some time later, unless
I setpci the bits off by hand.)

-- 
NULL && (void)