Re: route add default fails with ESRCH?

	Hello,

On Wed, 22 Feb 2012, Arun Sharma wrote:

Without this my eth0 driver complains about link not being ready.

quoted

quoted

# cat /proc/net/fib_trie

	Where is "Main:" here?

I think answering this is key.

	Main is not printed only when the main table is
empty. The table name is printed only if there are nodes
in the table. May be all rules (ESRCH) and all routes (no Main)
are flushed.

This is the main difference between systems that work and the ones that don't.
Systems that work have a non-empty Main table:

# cat /proc/net/fib_trie
Main:
  +-- 0.0.0.0/0 4 3 10
     +-- 0.0.0.0/4 1 0 0
        |-- 0.0.0.0
           /0 universe THROW

I'll try to figure out why my RT_TABLE_MAIN was empty after my network startup
scripts finished. But given my experience with 2.6.38, fib_hash handled this
case just fine and fib_trie broke it :(

	printk for current->comm should show the process name
that removes the routes. If problem is ifup-local I remember
only for one difference: fib_trie can list 0.0.0.0/0 before
other routes but ip route flush default simply removes all
routes, even on old kernels. May be route del default gw...
does not delete the default route and then
'ip route flush default' does the bad job.

Regards

--
Julian Anastasov [off-list ref]