[PATCH] stmmac: Use correct MDIO bus name so that phy_connect() works again
From: Stefan Roese <sr@denx.de>
Date: 2012-01-26 14:47:24
Subsystem:
networking drivers, stmmac ethernet driver, the rest · Maintainers:
Andrew Lunn, "David S. Miller", Eric Dumazet, Jakub Kicinski, Paolo Abeni, Maxime Chevallier, Linus Torvalds
Patch db8857bf [stmmac: use an unique MDIO bus name.] changed the MDIO bus name. After this phy_connect() fails. This patch changes the bus name in stmmac_mdio.c so that the name matching works again. Signed-off-by: Stefan Roese <sr@denx.de> Cc: Florian Fainelli <florian@openwrt.org> Cc: Giuseppe Cavallaro <redacted> --- drivers/net/ethernet/stmicro/stmmac/stmmac_mdio.c | 2 +- 1 files changed, 1 insertions(+), 1 deletions(-)
diff --git a/drivers/net/ethernet/stmicro/stmmac/stmmac_mdio.c b/drivers/net/ethernet/stmicro/stmmac/stmmac_mdio.c
index da4a104..7319532 100644
--- a/drivers/net/ethernet/stmicro/stmmac/stmmac_mdio.c
+++ b/drivers/net/ethernet/stmicro/stmmac/stmmac_mdio.c@@ -154,7 +154,7 @@ int stmmac_mdio_register(struct net_device *ndev) else irqlist = priv->mii_irq; - new_bus->name = "STMMAC MII Bus"; + new_bus->name = "stmmac"; new_bus->read = &stmmac_mdio_read; new_bus->write = &stmmac_mdio_write; new_bus->reset = &stmmac_mdio_reset;
--
1.7.8.4