Re: RFC - should network devices trim frames > soft mtu

On Wed, Aug 31, 2011 at 03:27:31PM -0700, Michael Chan wrote:

quoted

This means that for non-VLAN tagged frames, the device drops received
packets if the length is greater than the MTU.  I don't see that in
other devices. What is the correct method? IMHO the bnx2 driver is
wrong here and if the policy is desired it should be enforced at
the next level (netif_receive_skb).  Hardcoding a protocol value is
kind of a giveaway that something is fishy.

I guess the reasoning is that we program the RX MTU in our chip to
automatically discard packets bigger than the RX MTU and count them as
over-size packets.  We add 4 bytes to the RX MTU to account for the VLAN
tag which may be stripped or not stripped by the chip depending on
settings.  The extra 4 bytes in the RX MTU setting will allow over-size
packets by up to 4 bytes to get through.

I agree we should move this to the next level.

802.3ac allows both unconditionally raising the MTU to 1522 as well as
checking the protocol and only accepting 802.1Q frames at 1522 while
restricting everything else to 1518.

802.3as raises the bar to 2000 bytes, but explicitly states that the
actual payload - without encapsulation headers from 802.1Q, 1ad, 1ah,
MPLS & co. - should keep the 1500 byte limit.

I think the sensible approach would be to move the MTU check as close
as possible to the border between ethernet and the upper layer
protocols, i.e. the driver shouldn't check this at all and try to tx/rx
as much as the hardware supports. This is needed for QinQ, 802.1ah & co.


-David