[PATCH] dsa/mv88e6060: support nonzero mii base address
From: Peter Korsgaard <jacmet@sunsite.dk>
Date: 2011-03-07 15:50:19
Subsystem:
networking [dsa], networking [general], the rest · Maintainers:
Andrew Lunn, Vladimir Oltean, "David S. Miller", Eric Dumazet, Jakub Kicinski, Paolo Abeni, Linus Torvalds
The mv88e6060 uses either the lower 16 or upper 16 mii addresses, depending on the value of the EE_CLK/ADDR4 pin. Support both configurations by using the sw_addr setting as base address. Signed-off-by: Peter Korsgaard <jacmet@sunsite.dk> --- net/dsa/mv88e6060.c | 7 ++++--- 1 files changed, 4 insertions(+), 3 deletions(-)
diff --git a/net/dsa/mv88e6060.c b/net/dsa/mv88e6060.c
index 83277f4..8f4ff5a 100644
--- a/net/dsa/mv88e6060.c
+++ b/net/dsa/mv88e6060.c@@ -18,7 +18,7 @@ static int reg_read(struct dsa_switch *ds, int addr, int reg) { - return mdiobus_read(ds->master_mii_bus, addr, reg); + return mdiobus_read(ds->master_mii_bus, ds->pd->sw_addr + addr, reg); } #define REG_READ(addr, reg) \
@@ -34,7 +34,8 @@ static int reg_read(struct dsa_switch *ds, int addr, int reg) static int reg_write(struct dsa_switch *ds, int addr, int reg, u16 val) { - return mdiobus_write(ds->master_mii_bus, addr, reg, val); + return mdiobus_write(ds->master_mii_bus, ds->pd->sw_addr + addr, + reg, val); } #define REG_WRITE(addr, reg, val) \
@@ -50,7 +51,7 @@ static char *mv88e6060_probe(struct mii_bus *bus, int sw_addr) { int ret; - ret = mdiobus_read(bus, REG_PORT(0), 0x03); + ret = mdiobus_read(bus, sw_addr + REG_PORT(0), 0x03); if (ret >= 0) { ret &= 0xfff0; if (ret == 0x0600)
--
1.7.2.3