On Wed, Jul 29, 2009 at 08:49:35AM -0700, Julia Lawall wrote:

The function tg3_reset_hw in the file drivers/net/tg3.c contains the code:

	/* If statement applies to 5705 and 5750 PCI devices only */
	if ((GET_ASIC_REV(tp->pci_chip_rev_id) == ASIC_REV_5705 &&
             tp->pci_chip_rev_id != CHIPREV_ID_5705_A0) ||
	    GET_ASIC_REV(tp->pci_chip_rev_id) == ASIC_REV_5750) {
                if ((tp->tg3_flags & TG3_FLG2_TSO_CAPABLE) &&
                    (tp->pci_chip_rev_id == CHIPREV_ID_5705_A1 ||
	             tp->pci_chip_rev_id == CHIPREV_ID_5705_A2)) {
	                /* nothing */
	        } else if (!(tr32(TG3PCI_PCISTATE) & PCISTATE_BUS_SPEED_HIGH) &&
	                   !(tp->tg3_flags2 & TG3_FLG2_IS_5788) &&
			   !(tp->tg3_flags2 & TG3_FLG2_PCI_EXPRESS)) {
			val |= WDMAC_MODE_RX_ACCEL;
	        }
	}


On the fifth line above there is the code:

tp->tg3_flags & TG3_FLG2_TSO_CAPABLE

but the tg3_flags field seems to normally have a value whose name contains 
FLAG, and not FLG2.  Should this code be:

tp->tg3_flags2 & TG3_FLG2_TSO_CAPABLE

or should the constant be different?

On all the copies of tg3.c I have readily available, the line says :

tp->tg3_flags2 & TG3_FLG2_TSO_CAPABLE

Even the latest net-next tree is like this.  Where did you get your
source from?